FRANÇAIS
PRODUIT : Armoire de charge
INSTRUCTIONS
1. Brancher le câble d'alimentation à la prise secteur
2. Allumer l'armoire de charge en appuyant sur le bouton ON/OFF
3. Connecter votre câble USB de charge l'armoire, puis à votre produit
4. Ranger le produit dans le compartiment dédié
CONFIGURATION DU CODE (Figure 1)
1. Le code par défaut est 0-0-0-0
2. Tournez le bouton en position «OPEN».
3. Pousser la goupille en position «B»
4. Faites défiler les chiffres pour définir le nouveau code
5. Repousser la goupille à la position initiale «A».
Conseils :
- Assurez-vous de pouvoir verrouiller/déverrouiller avec le nouveau code avant de
verrouiller un objet.
- Conservez le code et la clé Master dans un endroit sûr pour toute référence
ultérieure.
RETRAIT DU CODE (Figure 2)
1. Utilisez la clé principale pour ouvrir la serrure
2. Appuyez sur chaque détendeur et faites défiler le numéro correspondant jusqu'à
ce qu'il s'arrête. Les 4 derniers chiffres affichés sont le code
ATTENTION
Tenir à l'écart de l'eau, du feu ou de tout liquide et hors de la portée des
enfants.
Éviter d'exposer le produit à des périodes prolongées de chaleur ou de froid
extrême.
Un personnel qualifié doit remplacer le produit afin d'éviter tout danger.
Ne pas démonter ou tenter de réparer ce produit vous-même.
RÉSOLUTION DES PROBLÈMES
Si l'appareil semble ne pas fonctionner, veuillez vérifier les points suivants :
L'armoire de charge est bien branchée à une prise alimentée.
Le câble USB est correctement branché dans l'un des ports USB.
ENREGISTREMENT PRODUIT
PORT EUROPE vous recommande d'enregistrer votre produit dans les plus brefs
délais après son achat sur le site internet http://www.port-connect.com
SUPPORT APRES-VENTE
Pour les questions techniques relatives à votre produit merci de vous rendre dans la
section contact / support après-vente sur le site Internet http://www.port-connect.com
DIRECTIVE EUROPÉENNE 2012/19/UE
La directive Européenne 2012/19/UE sur les Déchets des Equipements Electriques
et Electroniques (DEEE), exige que les appareils ménagers usagés ne soient pas
jetés dans le flux normal des déchets ménagers. Les appareils usagés doivent
être collectés séparément afin d'optimiser le taux de récupération et le recyclage
des matériaux qui les composent et réduire l'impact sur la santé humaine et
l'environnement. Le symbole de la poubelle barrée est apposé sur tous les produits
pour rappeler les obligations de la collecte séparée. Les consommateurs devront
contacter les autorités locales ou leur revendeur concernant la démarche à suivre
pour l'enlèvement de leur appareil.
Figure 1
USER GUIDE
ENGLISH
PRODUCT : Charging tower
INSTRUCTIONS
1. Plug the power cable to the AC socket
2. Turn on the charging tower by pressing the ON/OFF switch
3. Connect your USB charging cable to the charging tower and then to your device
4. Store your device in the dedicated compartment
SETTING THE CODE (Figure 1)
1. The default code is 0-0-0-0
2. Turn the knob to the «OPEN» position.
3. Push the pin into position «B».
4. Scroll through the digits to set the new code
5. Push the pin back into position «A».
Tip:
- Make sure you can lock/unlock with the new code before locking an object.
- Keep the code and Master key in a safe place for future reference.
REMOVING THE CODE (Figure 2)
1. Use the master key to open the lock
2. Press each pusher and scroll through the corresponding number until it stops. The
last 4 digits displayed are the code
WARNING
Keep away from water, fire, liquids and out of the reach of children.
Avoid exposing the product to prolonged periods of extreme heat or cold.
Qualified personnel must replace the product to avoid a hazard.
Do not dismantle or attempt to repair this product yourself.
TROUBLESHOOTING
If the unit appears to have failed in functioning, please check the following:
The charging tower is plugged to a powerd socket.
The USB cable is correctly plugged to one of the USB port.
PRODUCT REGISTRATION
PORT EUROPE recommends that you register your product shortly after its
purchase on the website http://www.port-connect.com
TECHNICAL SUPPORT
For technical questions regarding your product, please go to the contact/-
support section on the website http://www.port-connect.com
EUROPEAN DIRECTIVE 2012/19/EU
The European Directive 2012/19/EU on Waste Electrical and Electronic Equipment
(WEEE), requires that old household electrical appliances must not be disposed of in
the normal household waste stream. Old appliances must be collected separately in
order to optimize the recovery and recycling of the materials they contain and reduce
the impact on human health and the environment. The symbol of the crossed out
dustbin is marked on all products to remind the obligations of separate collection.
Consumers should contact their local authority or retailer for information concerning
the correct disposal of their product
Figure 2
Pusher