Kenmore 79079623701 Instrucciones De Instalación página 9

Bridge Style Burners (some models)
Install Burner Caps, these include one Bridge Burner
Center Cap (rectangular shaped) and the two Bridge
Burner End Caps (The Bridge Burner End Caps will fit
either the front or rear Bridge Burner Head locations).
Make sure that the lips located under the Bridge Burner
Caps fall into the slots located in the Bridge Burner Head
(See arrows in Figure 12) and that all the Bridge Burner
Caps lie flat and evenly on the Bridge Burner Head.
Bridge Burner Head
I
Burner
Caps
Fig.13
Bridge
Burner
End
Cap
Bridge
Burner
Center
Cap
Igniter
Hole
iiiili!_i!! i
Bridge
Burner Igniter
End Hole
Cap
Fig. 12
Double Ring Style Burners (some models)
The Double Ring burner only operates properly with
two burner caps in place. Be sure the burner cap lips are
positioned facing down towards the burner head (Figure
13) and into the recessed areas (Figure 14) on each side
of the burner head. Be sure both burner caps are seated
firmly and rest level on the burner head before operating.
Check the fit for each cap using the same method for the
round burner caps by gently sliding each cap from side to
side. Pleasenote that the burner cap lips should NOT move
out of recessed areas of the burner head.
Recessed
area
Burner
Head
Fig. 14
2. Turn on Electrical Power and Open Main Shutoff
Gas Valve
3. Check the Igniters
Operation of electric igniters should be checked after
range and supply line connectors have been carefully
checked for leaks and range has been connected to
electric power. To check for proper lighting:
a. Push in and turn a surface burner knob to the LITE
position. All electronic surface ignitors will spark at the
same time. However, only the burner you are turning
on will ignite.
b.The surface burner should light once the flow of gas
reached the surface burner. Each burner should light
within four (4) seconds in normal operation after air
has been purged from supply lines. Visually check that
burner has lit.
c. Once the burner lights, the control knob should be
rotated out of the LITE position.
There are separate ignition devices for each burner. Try
each knob separately until all burners have been checked.
9