Before
You Call
(continued)
Won't Spin or Drain
• Unevenly
distributed
load,
Redistribute
the load, Close the lid and pull knob out.
check for leveling.
Be Sure
water !eve! is acceptab!e
for !oad Size.
• Check fuse or reset Circuit breaker.
Straighten
drain hoses. E!imin ate kinked hoses,
If there is a drain restriction,
Cal! for Service.
• Close lid and pull knob out to start the washer,
For your Safety, washer
will not agitate or spin unless the lid is
Closed,
, The washer
is equipped
with a !id Switch failure detector. !f the !id Switc h Should malfunction,
the detector will
stop operations
for your safety. Call for service.
• Suds lock = caused by too much Suds. Rewash
without
detergent.
Use Correct amount
of a low-sudsing
deter,
genL
, Unevenly
distributed
load.
Redistribute
the load, close the lid and pull knob out.
Check for leveling.
Be Sure
water !eve! is acceptab!e
f0r !0ad Size.
, Plug Cord int0 !ire e!ectrica! outleL
Check fuse or reset circuit breaker.
• Turn the control knob to proper
Cycle and pull knob out to Start the washer.
• Close lid and pull knob out to start the washer.
For your safety, washer
will not agitate or spin unless
lid is
closed.
' This may be a pause or Soak period
in the Cycle, Whit briefly and it may start.
• _e
washer is equipped
with a lid Switch failure detector. If the lid Switch should
malfunction,
the detector
will
stoP fi!! 0perati0ns
f0r your safety. Ca!! f0r Service:
Is Noisy
• Be Sure washer
is leveled properly
as Outlined in installation
manual.
' Weak fl0ors can Cause yibration
and walking.
Be Sure robber
feet are instal!ed
on leveling
legs.
•
IM
A clicking sound
may be the LoadSensor
i agitator as it moves
the !oad down through
the cleaning
zone for
maximum
Cleaning effectivness.
This sound wi!! vary from !oad to load. This is norma!.
,
Operat_g
S0_ds
wi!! vary depend_g
on agitation
Speed,