EN
• Connector FDD
Power supplies are intended to be installed by professional staff or technical service.
Basic guidelines for installation and started:
1. Open the PC box following its instruction manual and remove the previous power supply. To do this, disconnect all
connections and remove the screws that secure it. Place the new power supply in the same place.
2. Locate and connect the ATX, 20 or 20+4 pin main connector on the motherboard. If the motherboard has only 20
pins, separate the additional 4 pins.
3. Perform the same process with the secondary cable that supplies an additional 12V. This cable usually has 8 pins
(4 + 4), but only four may be required depending on the type of motherboard.
4. Connect each of the hard drives and optical drives using the SATA, MOLEX or FDD connectors provided for them.
Keep in mind that each device requires its power and data cable to be connected.
5. Finally, if you have a graphics card that requires additional power, locate and connect the PCI-e connector (6 + 2) pins
on your graphics card, allowing the separation of these additional 2 pins depending on the power you need.
6. Once the installation is complete, connect the power cord to the power and set the switch to "I" position, then
turn on the computer.
Pin
Description
Color
1
+12.0V
Yellow
2
COM
Black
3
COM
Black
4
+5.0V
Red
12