Preparing The Appliance For Operation - SEVERIN KS 9865 Manual De Instrucciones

Preparing the appliance for operation

! It is recommended to prepare the appliance for operation with a helper.
 Remove package. Lift the appliance away from foamed polystyrene base. Tear off adhesive tapes.
 When positioning the appliance in chosen location, it will move more easily into position if you lift the front a
little and incline it backward, allowing it to roll on its casters.
detail will fall out – IT IS FOR TRANSPORTATION PURPOSES ONLY.
 Suitably dispose the packaging material.
 Take two supports from the bag and insert them into the guides at the top back
part of the appliance.►
Positioning
 Place the appliance in a dry, well ventilated room.
 WARNING! The appliance should not be operated in an unheated room or porch. Place the appliance away
from heat sources such as kitchen stove/oven, radiators, or direct sunlight.
 WARNING! The appliance must not touch any pipes for heating, gas or water supply, or any other
electrical devices.
 Do not cover the ventilation holes at the top of the appliances– it must be a good air
circulation around the appliance. There should be a gap of at least 10 cm between the
top of the appliance body and any furniture that may be above it (fig. 5). If this
requirement is not followed, the appliance consumes more electrical energy and its
compressor may overheat.
Changing the interior light bulb
When changing the interior light bulb, do the actions below in the order they are
listed:
1. Unplug the appliance from the mains by pulling the plug out of the
electricity supply socket.
2. Squeeze the sides of the light fixture cover 1 to unhook the cover fasteners A
and pull downward. Remove the cover.
3. Replace the light bulb with the same 15 W type light bulb with the E14 lamp holder.
4. After changing the light bulb, put the cover fastener hook in place B and then press upward until it's fixing
in place. Plug the appliance into the electricity supply socket.
 Remove all red-coloured parts from the
shelves (fig. 2). Tear away the red-
coloured adhesive tapes from the door
trays – they are intended only for the
transport of the appliance.
NOTE. When you open the freezer
compartment door a little red packing
◄ If the appliance is placed in a corner,
a gap of at least 1 cm must be left
between the appliance body and the
wall so that the freezer compartment
door can be opened enough to pull out
the frozen product drawer.
 The appliance must stand on a level
surface and must not touch the wall.
If necessary, regulate the height of
the appliance by adjusting the
levelling feet: by turning them
clockwise – the front of the appliance
rises, by turning them counter clockwise – it comes down. If
the appliance is tilted slightly backward – the doors will
close by themselves.
32
GB