SEVERIN BA-3299 Instrucciones De Uso página 10

●
Always switch the appliance off and
remove the plug from the wall socket
before the water reservoir is removed;
this will prevent the appliance from being
damaged.
●
Do not allow the power cord to touch
hot surfaces. Do not coil the power cord
round the appliance.
●
Always remove the plug from the wall
socket
- after use,
- in case of any malfunction,
- during cleaning,
- while refilling, when the reservoir is
removed.
●
When removing the plug from the wall
socket, never pull on the power cord;
always grip the plug itself.
●
This appliance is not intended for use by
any persons (including children) with
reduced physical, sensory or mental
capabilities, or lacking experience and
knowledge, unless they have been given
supervision or instruction concerning the
use of the appliance by a person
responsible for their safety.
●
Children should be supervised to ensure
that they do not play with the appliance.
●
Caution: Keep any packaging materials
well away from children: there is a risk of
suffocation.
●
No responsibility will be accepted if
damage results from improper use, or if
these instructions are not complied with.
●
This appliance is intended for domestic
use only and not for commercial
applications.
●
In order to comply with safety
regulations and to avoid hazards, repairs
of electrical appliances must be carried
out by qualified personnel, including the
replacement of the power cord. If repairs
are needed, please send the appliance to
one of our customer service departments.
The address can be found in the
appendix to this manual.
Anti-scale filter
A special filter in the generator reservoir
softens the water and reduces the build-up of
lime deposits in the sole plate.
Filling with water
- The steam generator is equipped with a
special anti-scale filter and is not
therefore liable to the build-up of lime
deposits.
- Before the steam function can be used,
the water reservoir must be filled with
water as follows:
- Switch off the generator and remove
the plug from the wall outlet.
- Push the release button inside the grip
recess up and keep it depressed.
- Lift out the reservoir.
- Lift out the anti-scale filter.
- Fill the reservoir with clean tap water,
observing the 'Max' marking on the
reservoir.
- Replace the anti-scale filter.
- Place the water reservoir into the
generator, ensuring it locks into place.
- Once the water has been used up during
ironing, the sound of the pump increases
as air is pumped instead of water. This is
perfectly normal and no cause for
concern. Re-fill the reservoir as described
above.
Main indicator light - pump
When the steam jet button or the steam
button is pressed during ironing, the main
indicator lamp for the pump comes on,
showing that the pump is active.
If the steam jet button or the steam button is
pressed when all the water has been used up,
the temperature in the working pump
increases. Once the maximum operating
temperature for the pump has been reached,
the integral thermal safety cut-out switches
the pump off; this is indicated by the main
indicator lamp for the pump which goes out.
If this occurs, switch the generator off. Fill
the reservoir with clean water and replace
the reservoir in the steam generator,
10