Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
BASIC SETUP
Getting Started
1.
Ensure all power is turned off on the PM 801 Personal
Mixer. To totally ensure this, the AC cable should not be
connected to the unit.
2.
All level controls should be set at all the way to the left
and all channels muted to ensure no sound is inadvertently
s
e
t n
h t
o r
u
g
h
h t
e
o
u
p t
u
s t
w
All levels can be changed to acceptable degrees after the
device is turned on.
3.
Plug all necessary instruments and equipment into the
device's various inputs as required. This may include
line level devices, as well as microphones and/or guitars,
keyboards, etc.
4.
Plug any necessary equipment into the PM 801's output
jack and pre-fader output. These outputs can be sent to
various devices, such as amplifiers, active speakers or
monitors, signal processors, and/or recording devices.
5.
Plug the supplied AC cable into the AC inlet on the back
of the device ensuring the local voltage level is identical to
that required on your device.
6.
Plug the supplied AC cable into a power outlet of a suitable
voltage.
7.
Turn the power switch on.
2
h
e
n
h t
e
d
e
v
c i
e
s i
s
w
c t i
h
e
d
o
. n
Channel Setup
1.
To ensure the correct audio levels of each input channel
is selected, every channel should first be muted and all
VRs turned all the way to the left (including the main output
control).
2.
Choose the channel that you wish to set the level of, and
ensure that channel has a signal sent to it similar to the
signal that will be sent when in common use. For example,
if the channel is using a microphone, then you should
speak or sing at the same level the performer normally
would during a performance. If a guitar is plugged into that
channel, then the guitar should also be used as it normally
would be.
3.
Set the level control of the selected channel to a level that
allows the clip LED to illuminate occasionally; then turn it
back slightly to ensure the LED does not illuminate. This
will allow you to make full use of the channel's signal.
4.
This channel is now ready to be used; you can stop making
the test audio signal.
5.
To activate the channel, release the mute button.
6.
You should now select the next channel to set and go back
to follow steps 1 through 5.
Note: it is possible to connect two PM 801's together through the
Prefader Outputs and AUX Bus Inputs of each, allowing
a total of 16 inputs to be used, all controlled through a
single fader (or both faders, and sending the same signal
to 2 separate external devices).
PM801
V10
Publicidad
Capítulos
Tabla de contenido
