SEVERIN KS 9816 Instrucciones De Uso página 16

∙ To prevent an increased build-up of ice, do not leave the
freezer door open for too long when loading or taking out
food.
∙ Frequent de-frosting helps to save energy. For detailed
information on cleaning the appliance, please refer to the
section De-frosting and cleaning.
∙ Do not set a lower-than-necessary temperature. For
detailed information on the temperature settings, please
refer to the section Temperature control.
Trouble-shooting
Certain typical sounds can be heard when the appliance is
switched on. These sounds are:
∙ caused by the
electrical motor within
the compressor
assembly; during
compressor start-up
the sound level will be
slightly higher for a
limited period of time.
∙ caused by the cooling agent fl owing through the circuit.
Problem
The unit is not working.
The unit seems to generate
insuffi cient cooling power.
The normal operating sound
changes or becomes louder.
Transporting the appliance
To prevent damage to the unit during transport, ensure that
all accessories and components inside and around the
appliance are securely fastened.
The unit must only be transported in its vertical position; do
not tilt any more than 30°.
Once the unit has been positioned, wait for about 30
minutes before it is connected to the mains.
If the unit has been tilted more than 30° during transport,
allow it to stand in an upright position for at least 4 hours
before it is connected to the mains.
16
Possible cause and solution
Check that
∙ the switch in your home installation fuse box is switched on.
∙ the wall socket is working. This can be done by connecting another electrical device to
the socket and checking for function.
Check whether
∙ too much food has been stored in the unit.
∙ the thermostat is set to position 'COLD' (in this case, set it to a suitable higher value).
∙ the door is not properly closed.
∙ there is too much dust on the condenser.
∙ the unit is too close to a wall or other object at the rear or to the sides.
Check whether
∙ the unit has been properly positioned.
∙ any objects or obstructions are touching the rear of the unit.
∙ there are any objects on top of the unit which might be vibrating.
The following table lists the possible malfunctions, their
probable causes and solutions. In the event of operational
problems, c heck fi rst whether a solution can be found using
this table. If the problem persists, disconnect the appliance
from the mains power and contact our Customer Service
Department.
Disposal
This appliance has been manufactured from
recyclable materials. After removing the plug from
the wall socket, the unit should be rendered
unusable by cutting off the power cord before
being disposed of through special waste collection points in
accordance with local regulations. The refrigerant and the
chemical agent in the insulation foam must be disposed of
through a competent agency. Take special care not to
damage the cooling circuit before the unit is handed over for
competent disposal.