Connections, Operating And Display Elements - Cameo HydraBeam 4000 RGBW Manual De Usuario

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

6
2
1
POWER IN
Blue power input socket for power supply to the device. A suitable power cable is included.
2
POWER OUT
White power output socket for power supply to additional CAMEO lights. Ensure that the total current consumption of all connected devices
does not exceed the value specified on the device in amperes (A).
3
FUSE
Fuse holder with F3AL / 250 V fuse (5 x 20 mm). IMPORTANT: When replacing the fuse, only use a fuse of the same type and value. In the
event of repeated fuse failure, please contact an authorised service centre.
4
POWER
On / off switch.
5
DMX IN
Male 3-pin and 5-pin XLR sockets for connection to a DMX control device (e.g. DMX console).
6
DMX OUT
Female 3-pin and 5-pin XLR socket for sending the DMX control signal.
7
LC DISPLAY
The LED display shows the operating mode and other system information.
8
OPERATING KEYS
MENU
Press MENU to access the selection menu for system settings. Press repeatedly to go back to the main display.
UP and DOWN
Select individual items in the selection menu and sub-menus for system settings (DMX address, operating mode etc.). Change settings in
the menu items.
ENTER
Press ENTER to access the menu levels and change values as required, e.g. the DMX address. Confirm value changes.
9
EYELET FOR SAFETY CABLE
Overhead installation may only be carried out by qualified personnel. A suitable safety cable must be fitted to the floodlight's eyelet to
ensure that it does not fall down.
9 7
8
4
5
3
1
5