SEVERIN KS 9886 Instrucciones De Uso página 11

Installation
 The appliance should be set up in a well-ventilated, dry room.
 It should be operated in conditions where the relative humidity is no more than 70 %.
 The product data sheet contains details of the ambient temperature range suitable for this
appliance.
 Do not use the appliance outdoors.
 Ensure that the plug is accessible and can be removed from the wall socket at any time.
 Do not expose the appliance to direct sunlight, and do not position it next to any heat sources
(radiators, cookers etc). If this cannot be avoided, however, suitable insulation must be in
installed between the heat source and the unit.
 To ensure sufficient air circulation, maintain a minimum distance of 50 mm between the rear of
the unit and the wall. The top clearance must be at least 150 mm.
 The unit must not be installed inside a cabinet, nor directly below a hanging cupboard, shelf or
similar object.
 If the floor is uneven, the adjustable feet on the unit can be used to compensate and ensure
optimum stability. The whole unit should be installed at a slight angle in such a way that it leans
to the rear: this will ensure that the door closes automatically. However, both front feet must be
set to the same height.
Ventilation
The heated air around the unit must be able to circulate freely. Therefore, ensure that the circulation
is not obstructed.
Reversible door
The design provides for the door to be reversed, i.e. for right-hinged (default installation) to become
left-hinged. Additional blind covers are enclosed in a plastic bag in case the door needs to be
reversed.
– Remove the upper hinge cover (1).
– Use a suitable screw-driver to remove the covers
(5).
– Use a screw-driver to remove the two screws (2)
holding the upper hinge to the right side of the
housing.
– Carefully lift up the door and place it on a soft
surface to protect it from scratches.
– Remove the blind cover (9) for the hinge mounting
hole and fit it in the corresponding place on the
right-hand side of the door. Ensure that the cover
is firmly pushed down into the hole.
– Pull off the two bolts (7) which hold the lower
hinge (4) in position on the right.
– Unscrew the adjustable foot (8) and re-fit it on the
right-hand side.
– Replace the door in its new position. Ensure that the hinge pin is inserted into the guide bushing
(hole) on the lower part of the housing.
– Install the upper hinge (3) on the left-hand side, using the screws (2). Ensure that the hinge pin is
inserted into the guide bushing (hole) on the upper part of the housing.
– Install the lower hinge (4) loosely. The bolts (7) should be tightened only after the door is closed
and adjusted to its proper position.
11