Surtek TM612 Manual De Usuario Y Garantía página 14

1
5
1. FIXED HEAD.
2. MOBILE HEAD.
3. ADJUSTING STEERING WHEEL.
4. MOBILE HEAD SCREW.
5. STANDARD JOB SUPPORT.
ASSEMBLY INSTRUCTIONS
TO ASSEMBLE THE BASE
1. Carefully remove the leg set and wood lathe
from the carton.
CAUTION: THE WOOD LATHE IS VERY
HEAVY AND MUST BE LIFTED WITH THE HELP
OF 2 PEOPLE OR MORE. THE ASSEMBLY PRO-
CESS REQUIRES 2 PEOPLE OR MORE TO SAFETY
ASSEMBLE THE LATHE TO THE LEG SET.
2. Separate the parts for the leg set from the
parts of the lathe.
3. Lay out all parts and check them against the
parts listed below. Examine all parts carefully.
WARNING: IF ANY PART IS MISSING OR
DAMAGED, DO NOT PLUG THE WOOD LATHE
IN UNTIL YOU HAVE REPLACED THE MISSING
OR DAMAGED PART.
For you satiety, complete the assembly of the
lathe before plugging it into the power supply.
1. Lathe bed assembly.
2. Face plate.
3. Headstock spur center.
4. Tail stock cup center.
5. Push rod.
6. Flat wrench.
7. Hex key.
8. Instruction manual.
9. Hex bolt and nut.
10. Stand.
11. Handle.
12. Extension bed.
14
4
2
3
LEG SET ASSEMBLY
Attach one front leg and one back leg (1) to
the outside edges of the top plate (2) using car-
riage bolts (3), washers (4) and nuts (5). The top
plate (2) should fit inside the legs (1). Do not
tighten nuts at this time.
Repeat this procedure for the remaining legs
and top plate. Attach the long plate (6) to the
legs using carriage bolts, washers and nuts.
Place the leg stand on a level surface and tight-
en all nuts securely using a 14 mm wrench.
INSTALLING THE LATHE ON THE LEG SET
CAUTION: The lathe is heavy, use assistance
for lifting.
Place the lathe unit on the leg set.
Position the headstock (2) assembly over the
top plate and align the holes of the lathe bed
(3) with the holes in the top plate (4).
Align the tail stock assembly bolt holes with
the top plate holes.
Install the Allen bolts (5) into all of the mount-
ing holes and through the top plates.