SEVERIN BT 7742 Instrucciones De Uso página 8

Use
General information
The appliance is designed to remove
unwanted facial hair and to trim eyebrows or
hair around the nape.
To achieve best results, use the fingers of
your free hand to tighten the skin area being
treated.
Before using for the first time
Before the appliance is used for the first
time, and also after extended periods of non-
use, it should be thoroughly cleaned as
described in General care and cleaning.
Operation
Removing/trimming facial hair
- Take off the protective cover.
- Use the On/Off switch to turn the
appliance on.
- Position the trimming head gently against
the skin.
- Move the shaving head slowly against the
natural growth of the hair.
- Areas to be treated:
- Above the eyebrows (forehead)
Cut the facial hair from the hairline
towards the centre of the forehead and
then back to the hairline.
- Cheeks (picture I)
Move the trimming head on the cheek
from the centre outwards.
- Upper lip (picture II)
Stretch the upper lip and move the
appliance downwards from the top.
- Cheek hair (in front of the ear)
Cut with a downward motion starting
from the desired point.
- Below the eyes
Use your fingers to tighten the skin and
cut the hair towards the outside,
starting from the centre (nose area).
- Neck line (nape of the neck)
Use your fingers to tighten the skin and
move the trimming head with an
upward motion along the neck area.
- Use the On/Off switch to turn the
appliance off.
Trimming the eyebrows (picture III)
- Take off the protective cover.
- Fit the eyebrow comb to the required
length over the trimming head.
- Use the On/Off switch to turn the
appliance on.
- Gently place the trimming head with the
eyebrow comb against the skin.
- Move the trimming head slowly against
the against the natural growth of the hair.
- Use the On/Off switch to turn the
appliance off.
- Take the eyebrow comb off the trimming
head
General care and cleaning
●
Always switch the appliance off before
cleaning.
●
To prevent damage to the appliance, do
not allow it to come into contact with
liquid and do not immerse it.
- Any hair clinging to the appliance after
use should be removed with a brush, or
by blowing.
- For thorough cleaning, push the safety
slide on the trimming head towards the
battery compartment cover and remove
the head. Use a brush to clean both
sections of the head. A drop of oil should
be applied frequently, any excess oil
being wiped off with a cloth. Re-
assemble both sections of the trimming
head and secure it by bringing the safety
slide back into its previous position.
Disposal
Do not dispose of old or defective
appliances in domestic garbage;
this should only be done through
public collection points.
Guarantee
This product is guaranteed against defects in
materials and workmanship for a period of
two years from the date of purchase. Under
8