LAVOR Pro THERMIC 10 D Manual Del Usuario página 15

intake. The water intake should be at least twice
the pump capacity.
- Minimum delivery rate: 15 l/min
- Maximum intake water temperature: 40°C
- Max inlet water pressure: 1Mpa
Place the cleaner as close as possible to the wa-
ter supply.
Water supply from the water main
Connect a supply hose (not included) to
the water inlet of the unit and to the water
supply.
Open the water supply.
The cleaner can be connected directly to the
mains drinking water supply only if the supply
hose is fitted with a backflow preventer valve as
per current regulations in force.
Make sure that the hose is at least Ø 13mm and
that it is reinforced.
WARNING: Water that has flown through
backflow preventers is considered to be
nonpotable.
Water supply from an open container
Unscrew the coupling part for the water
inlet.
Screw the suction hose with filter (not in-
cluded) onto the water connection of the
unit.
Hang the filter in the container.
Vent the unit before operation.
- Unscrew the high-pressure line at the
high-pressure outlet of the unit.
- Switch on the unit and let it run until
water free of bubbles emerges at the
high-pressure outlet.
- Switch off the unit and screw on the
high-pressure hose again.
Failure to comply with the above conditions
causes serious mechanical damage to the
pump and the loss of warranty cover.
fig. 5
1. Connect the high pressure hose to the unit's high
pressure outlet (fig. 5).
2. Connect the high pressure hose to the spray gun.
Insert the spray wand of your choice into the wand
extension. Press in against the spring tension and
twist into the locked position (fig. 6). Insert the noz-
zle (fig. 2A).
3. Connect garden hose to unit's water inlet (Max
10 bar, max t. 40° C) (fig. 7).
fig. 7
4.Connect garden hose to the cold water source
and turn water on completely (fig. 8).
5. Trigger the gun to eliminate trapped air, wait for
a steady flow of water to emerge from the spray
nozzle (fig. 9).
fig. 9
Start the motor: see "owner's manual - general
engine".
CAUTION: Turn off the machine when finished
working.
CAUTION: When the machine is switched off,
always discharge the pressure hose, opening the
gun.
MAINTENANCE
CAUTION: Before to carry out any kind of
fig. 6
13 mm
fig. 8
15