Standard Installation (Without Ez1 Brackets); Install The Hood (Standard Installation) - Kenmore 233.5139 Serie Manual De Uso

1. Use these diagrams for proper placement of ductwork
and electrical cutout in cabinet or wall.
For a non-ducted installation, DO NOT cut a duct access
hole, only cut the hole for electrical wiring.
HOOD MOUNTING SCREWS (4)
12⅞" (30" )
HOOD
7-IN. ROUND 7-IN. ROUND 7-IN. ROUND
ACCESS ACCESS ACCESS
4¹¹/ "
16
WOOD SHIMS
( -
RECESSED BOTTOM
)
CABINETS ONLY
2. Install part-way four (4) ROUND HEAD no. 8 x 5/8"
mounting screws into shims/cabinet, according to the
proper diagram above. (Mounting screws are included
in parts bag, but wood shims and shim mounting screws
are not included)
NOTE: Two installers are recommended because of the weight of this hood.
1. Run house power cable between service panel and hood
location. Run the house power cable into the hood through
the strain relief previously installed in step 5 on page 8.
2. Hang hood from (4) mounting screws previously installed.
Slide hood back towards wall until mounting screw heads
are engaged in narrow end of keyhole slots in top of hood.
Tighten screws securely. Attach power cable to the hood
using the strain relief.
3. Connect the ductwork to the hood and use metal foil duct tape to make joints secure and air-tight. Make sure
the damper assembly (or round duct plate) enters the ductwork and that the damper opens and closes freely.

Standard Installation (without EZ1 brackets)

7" ROUND
VERTICAL DUCTING
12⅞" (30" )
HOOD
7³/ "
16
DUCT DUCT DUCT
1⅜"
8" DIA.
HOLE HOLE HOLE
HOLE
ELECTRICAL
ACCESS HOLE
(
IN CABINET BOTTOM

Install the Hood (Standard Installation)

DUCTED INSTALLATIONS ONLY
HOOD MOUNTING SCREWS (4)
WOOD SHIMS
(
RECESSED
CABINETS ONLY
10 / "
15
16
1½"
)
14
12⅞" (30" ) 12⅞" (30"
HOOD
CABINET FRONT
7³/
16
5¼"
5¼"
VERTICAL DUCT
4 / " ACCESS HOLE
7
16
CENTER
-
BOTTOM
LINE
)
HORIZONTAL DUCTING
WOOD SHIMS
( -
RECESSED BOTTOM CABINETS ONLY
CABINET FRONT
3⅞" HORIZONTAL DUCT
ACCESS HOLE
CABINET
BOTTOM
5¼"
12⅞" (30" )
HOOD
HOOD
CENTER
MOUNTING
LINE
SCREWS (4)
3¼" x 10"
VERTICAL DUCTING
)
HOOD
CABINET
BOTTOM
"
10 15 / "
16
1⅜"
3/4"
1½"
ELECTRICAL
ACCESS HOLE
( )
IN CABINET BOTTOM
3¼" x 10"
)
13/16"
3/16"
5¼"
7³/ "
16
12⅞" (30" )
HOOD
ELECTRICAL
ACCESS HOLE
( )
IN WALL