Gardena C 2030 duo plus Manual De Instrucciones página 20

1874-20.960.01_02.07.2011_GARDENA.qxp 18.07.2011 12:44 Seite 20
Connect Soil Moisture
Sensor or Rain Sensor
(optional) :
a b
K
2.
3.
Fit anti-theft device
(optional) :
L
M
20
In the case of rain, or when the soil is sufficiently moist, a
programmed, automatic watering programme will be stopped or
prevented from starting. Manual operation is possible at all times.
c
Sensor assignment :
a) A sensor in Connector 1 :
b) A sensor in Connector 2 :
c) Sensor in Connectors 1
and 2:
1. Place Soil Moisture Sensor in watered area
– or –
place Rain Sensor outside of the watered area.
2. Remove controller
Computer.
3. If necessary, connect sensor to Extension Cable or Adaptor
at the sensor connection
Activate sensor :
A sensor will be automatically activated after 60 sec. The sensor
a
assignment ,
dry / wet will be displayed.
E.g. Sensor 1 dry (dry) Valve 1
Deactivate sensor [Level 6] :
If watering is to be without a sensor, although a sensor was
previously activated, then this sensor must be deactivated.
1. Remove sensor from Water Computer.
2. Press Menu button 5 times [Level 6].
The sensor assignment
sensor status dry / wet will be displayed.
3. Press OK button.
The sensor has been deactivated.
To connect older sensors (with 2-pin connector), the GARDENA
Adapter Cable 1189-00.600.45 is required, which can be pro-
cured from GARDENA Service.
To secure your Water Computer against theft, you can obtain the
GARDENA Anti-theft device Art. No. 1815-00.791.00 from
GARDENA Service.
1. Screw clamp
Computer.
L
2. Use clamp
It is no longer possible to remove the screw after it has been
screwed in.
Sensor only applies to Valve 1
Sensor applies to both valves
Sensor 1 applies to Valve 1
Sensor 2 applies to Valve 2
F
from the housing of the Water
K
of the Water Computer.
b c
or (arrow) and the current sensor status
a
only.
a b c
, or (arrow) and the current
L M
with screw firmly to the back of the Water
e.g. for fixing a chain.