Ice Maker Care; Cleaning - Kenmore 106.8955 Serie Manual De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Cleaning

The ice making system and the air cooled condenser need to be
cleaned regularly for the ice maker to operate at peak
efficiency and to avoid premature failure of system
components. See the "Ice Maker System" and the "Condenser"
sections.
Exterior Surfaces
Wash the exterior enamel surfaces and gaskets with warm
water and mild soap or detergent. Wipe and dry. Regular use of
a good household appliance cleaner and wax will help maintain
the finish. Do not use abrasive cleaners on enamel surfaces as
they may scratch the finish.
For products with a stainless steel exterior, use a clean sponge or
soft cloth and a mild detergent in warm water. Do not use
abrasive or harsh cleaners. Do not use chlorine bleach on the
stainless steel surfaces.
Ice Maker System
Minerals that are removed from water during the freezing cycle
will eventually form a hard scaly deposit in the water system.
Cleaning the system regularly helps remove the mineral scale
buildup. How often you need to clean the system depends upon
how hard your water is. With hard water of 15 to 20 grains/gal.
(4 to 5 grains/liter), you may need to clean the system as often
as every 9 months.
NOTE: Use one 16 oz (473 mL) bottle of approved ice
maker cleaner, Part Number 4396808. To order, please call
1­800­4­MY-HOME
.
®
1. Press the ON/OFF button.
2. Wait 5 to 10 minutes for the ice to fall into the storage bin.
Remove all ice from the storage bin.
3. Unscrew the drain cap from the bottom of the water pan
located inside the storage bin as shown. Allow the water to
drain completely.
4. Replace the drain cap securely on the water pan. If the
drain cap is loose, water will empty from the water pan and
you will have either thin ice or no ice.
5. Read and follow all handling information on the cleaner
bottle before completing the steps below. Use one 16 oz
(473 mL) bottle of approved ice maker cleaner.
6. Pour one bottle of solution into the water pan. Fill the bottle
twice with tap water and pour it into the water pan.
16

ICE MAKER CARE

7. Press the CLEAN button. See "Using the Controls." The Clean
button will blink, indicating that the cleaning cycle is in
process. When the "Cleaning Complete" light is illuminated
(approximately 70 minutes), the cleaning cycle is complete.
During the cleaning cycle, the system will both clean and
rinse itself.
8. After the cleaning cycle is complete, remove the drain cap
from the water pan. Look for any cleaning solution left in the
water pan. If cleaning solution drains from the water pan,
you should run the clean cycle again. Be sure to refill the
water pan with cleaner before starting the clean cycle
again. Be sure to replace the drain cap securely on the
water pan. If the drain cap is loose, water will empty from
the water pan and you will have either thin ice or no ice.
NOTE: Severe scale buildup may require repeated cleaning with
a fresh quantity of cleaning solution.
9. Press the ON/OFF button to resume ice production.
Condenser
A Dirty or Clogged Condenser
Obstructs proper airflow.
Reduces ice making capacity.
Causes higher than recommended operating temperatures
which may lead to component failure.
Disconnect power before cleaning.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1. Unplug ice maker or disconnect power.
A. Water pan
B. Drain cap
WARNING
Electrical Shock Hazard
A
B

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

106.8959 serie

Tabla de contenido