Special Safety Instructions; Technical Data - Virax VAL96QC Manual De Instrucciones

SPECIAL SAFETY INSTRUCTIONS

Keep water away from any electrical parts of the power tool and from persons in the working area.
Never use the machine without a PRCD.
1 Be operated using an PRCD. The machine may only operated using a PRCD with a max. rated fault current of 10 mA.
2 Use gloves. Use special safety glove all time to reduce personal injuries.
3 Wear rubber boots (for insulation) when performing cleaning work.
3 Use hearing protection. Noise level when working can exceed 88 dB (A). Use ear protection all time!
4 Wear eye protection. When working with power tools there is a risk of floating soil. Wear eye protection to reduce
eye injuries.
5 The drain cable must be removed completely from the holding cage before machine is turned on.
6 Before inserting the plug into the electrical socket, make absolutely sure that the pipe cleaning machine is switched
to 0 or OFF.
7 To prevent damage, use this machine and its accessories only to clean waste water pipes — never chimneys, wells,
etc.
8 To prevent damage to the pipes or pipe bends, do not modify tools by sharpening them, etc.
9 Use a camera system to spot the cause of the pipe clog.
DESCRIPTION (FIG.1 et 2)
1 Guide hose
2 Protecting cap
3 Clutch and transport handle
4 Drain cable
5 Tool
6 On / Off switch
7 Power cable

TECHNICAL DATA

Voltage :
......................................................................................................................................................................
Rated power cons. :
Operating speed :
Working range :
...........................................................................................................................................
Max. working length :
Weight :
.......................................................................................................................................................................................
Typical weighted acceleration in the hand-arm area :
Sound pressure level (L
Sound power level (L
Protection class :
Noise level when working can exceed 88 dB (A). Use ear protection!
The typical weighted acceleration in the hand-arm area can exceed the declared value of 2,5 m/s². If you observe
increased vibrations stop working with power tool. Check the machine for dynamic unbalance.
WARNING: The drain cleaning machines are only designed for short term operation and may therefore only be
used for maximum continuous of 15 minutes (15 minutes work / 45 minutes break)
...........................................................................................................................................................
...........................................................................................................................................................
..........................................................................................................................................................
)
.......................................................................................................
pA
)
..........................................................................................................
WA
......................................................................................................................................................................
EN
8 PRCD
9 TEST switch
10 Indicator light
11 RESET switch
12 Male connector
13 Female connector
14 Decoupling key
.........................................................................
72 dB (A) | K
85 dB (A) | K
Page 8
230 V, 50 Hz
750 W
690 rpm
Ø 50 – Ø 150 mm
70 m
26 kg
2
< 2,5 m/s
3 dB (A)
pA
3 dB (A)
WA
IP44