DeWalt DHS716 Manual De Instrucciones página 10

FIG. 4
Q
P
O
N
E
M
Your saw is capable of cutting baseboard moldings 0.9" (22.9 mm) thick by 6" (152 mm) tall
on a 45º right or left miter.
NOTE: Your saw is capable of cutting the following once a special set-up procedure is
followed (see Special Cuts).
0° miter Height 1.5" (38 mm)
45º miter Height 1.5" (38 mm)
Familiarization
Your miter saw is fully assembled in the car ton. Open the box
and lift the saw out by the convenient lifting handle, as
shown in Figure 5. Place the saw on a smooth, flat surface
such as a workbench, strong table or D
e
stand. Examine Figure 4 to become familiar with the saw
and its various parts. The section on adjustments will refer
to these terms and you must know what and where the
parts are.
CAUTION: Pinch Hazard. To reduce the risk of injury,
keep thumb underneath the operating handle (A) when
I
K
L
E
H
G
Width 10" (255 mm)
Width 7.5" (190.5 mm)
FIG. 5
WALT miter saw
S
A
B
C
J
E
Y
F
pulling the handle down. The lower guard will move up as the handle is pulled down which
could cause pinching. The handle is placed close to the guard for special cuts.
Press down lightly on the operating handle and pull out the lock down pin (Q, Fig. 4). Gently
release the downward pressure and hold the arm allowing it to rise to its full height. Use the
lock down pin when carrying the saw from one place to another. Always use the lifting handle
to transport the saw or the hand indentations (M, Fig. 4).
COMPONENTS (Fig. 4)
WARNING: Never modify the power tool or any part of it. Damage or personal injury could
result.
A. Operating handle
B. Trigger switch
C. Trigger lock-off switch
D. Lower guard
E. Mounting holes
F. Miter lock lever
G. Miter release lever
H. Miter detent override
lever
8
D
R
X
I. Kerf plate R. Lifting handle
J. Miter scale pointer S. CUTLINE™ worklight
switch
K. Miter scale
T. Battery packs
L. Miter scale screws
U. Dust port
M. Hand indentations
V. Hex wrench
N. Fence
W. Bevel lock knob
O. Bevel scale
X. Clamp hole
P. Bevel scale pointer
Q. Lock down pin Y. Fence adjustment knob
T
U
Y
V
W