Installation With Gas Cooktops; Prepare Downdraft Housing - Bosch HDD80051UC Instrucciones De Instalación

INSTALLATION

Installation with gas cooktops

Dimension "BT" is thickness of
the backsplash that provides
1/2" (13 mm) clearance
between the vent and the
backsplash. Any backsplash
with a curved radius where it
meets the counter will require
additional clearance. Thicker
backsplashes may be used
by increasing the counter and
cabinet depths.
Set the cooktop into the
coutertop opening so that
the back edge of the cooktop
overlaps the leading edge of
the downdraft.

Prepare downdraft housing

1. Place the downdraft on its back on a table or fl at work
surface.
Upper
Support
Brackets
Discharge
Covers
Nuts
(keep)
2. Detach the upper support brackets from the downdraft
by cutting off the tie wraps. Remove and set aside both
support legs from sides of the downdraft (one leg per
side).
NOTE: Discard the retaining screws, but KEEP THE NUTS.
Remove the bundle of 3 dischage covers from the
bottom of the downdraft.
English 14
Downdraft cutout width:
30" (762 mm) is 27-1/16" (687 mm)
36" (914 mm) is 33-1/16" (840 mm)
BT
MIN.
1/2"
(13 mm)
1-7/8" (48 mm)
Support
Leg
Nut
(keep)
Screws
(discard)
Template
2-1/8" (54 mm)
1-1/16"
(27 mm)
Cooktop cutout width
3. Cover the discharge openings that won't be used for
ducting.
NOTE: Use the nuts previously removed for side discharge
covers.
24-11/16" (627 mm)
22-5/16" (567 mm)
19-1/8" (486 mm)
Measurements in inches (mm).