Publicidad
Idiomas disponibles
Idiomas disponibles
SM 2610929488 5-05
5/4/05
SWITCH
This
WARNING
!
recommended for use with
abrasive masonry cut-off wheels.
When starting the tool,
WARNING
!
hold the saw firmly to
prevent loss of control. The torque from the
motor can cause the tool to twist.
To turn tool "ON", squeeze the trigger switch.
To turn the tool "OFF", release the trigger
switch, which is spring loaded and will return
to the off position automatically.
Your saw should be running at full speed
BEFORE starting the cut, and turned off only
AFTER completing the cut. To increase switch
life, do not turn switch on and off while cutting.
GENERAL CUTS
Always hold the saw handle with one hand
and keep the other away from blade and line
of cut.
Always be sure either hand
WARNING
!
does not interfere with the
free movement of the lower guard.
Maintain a firm grip and operate the switch
with a decisive action. Never force the saw.
Use light and continuous pressure.
After completing a cut and
WARNING
!
the
trigger
released, be aware of the necessary time it
takes for the blade to come to a complete
stop during coast down. Do not allow the
saw to brush against your leg or side,
since the lower guard is retractable, it
could catch on your clothing and expose
the blade. Be aware of the necessary blade
exposures that exist in both the upper and
lower guard areas.
When cutting is interrupted, to resume cutting:
squeeze the trigger and allow the blade to
reach full speed, re-enter the cut slowly and
resume cutting.
3:46 AM
Page 10
tool
is
not
When cutting across the grain, the fibers of
the wood have a tendency to tear and lift.
Advancing the saw slowly minimizes this
effect. For a finished cut, a cross cut blade or
miter blade is recommended.
Disconnect the plug from the power source
before making adjustments. Set depth adjust-
ment according to material to be cut. Tilt saw
forward with cutting guide notch lined up with
the line you've drawn. Raise the lower guard,
using lift lever. (Fig. 9).
FIG. 9
LOWER
GUARD
LIFT LEVER
With the blade just clearing the material to be
cut, start the motor. Gradually lower the back
end of saw using the front end of the foot as the
has
been
hinge point.
WARNING
!
guard immediately. When the foot rests flat on
the surface being cut, proceed cutting in forward
direction to end of cut.
WARNING
!
the saw from cut. Also, never pull the saw
backward since blade will climb out of the
material and KICKBACK will occur.
Turn saw around and finish the cut in the normal
manner, sawing forward. If corners of your
pocket cut are not completely cut through, use a
jigsaw or hand saw to finish the corners.
-10-
CROSS CUTS
PLUNGE CUTS
LINE
GUIDE
As blade starts cutting the
material, release the lower
Allow blade to come to a
complete stop before lifting
FOOT
Publicidad
