Troubleshooting Guide - Peavey Escort 3000 Manual Del Usuario

Problem
No sound
(LCD not lit)
No sound
(LCD not lit)
No Effects
Files on USB memory device will not
play back
Loud howling or squeal from speakers
Sound is distorted
Output Power:
Frequency Response:
Overload Protection:
Distortion:
Signal/Noise Ratio:
AC Power:
Weight Assembled:
(stands included)
Dimensions:
Speakers:
Phantom Power:
Escort

3000 Troubleshooting Guide

®
Check
Is power switch on?
Is line cord connected to live power outlet?
Are MASTER and CHANNEL GAIN controls up?
Are the channel EFX controls turned up?
Is the master EFX MUTE enabled?
Is an effect activated in menu?
Is the file cued for playback?
Are the audio files the proper format?
If it goes away when the CHANNEL or MASTER LEVEL
controls are turned down, then it is acoustic feedback.
Is the CHANNEL GAIN at a very high setting?
Escort 3000 Specifications:
®
80 watts RMS (per channel)
40 Hz to 20 kHz +/-3 dB
10 dB of DDT
clipping that can damage the speakers
Less than 0.2% THD @ Max power
88 dB mic input typical
115 V AC 60 Hz or
230 V AC 50/60 Hz
50 lbs. (22.67 kg)
14.5" H x 36.75" W x 15.5" D
(36.8 cm x 93.3 cm x 39.4 cm)
Woofer 10" (254 mm)
Piezoelectric Horn Tweeter
15VDC Available on all XLR Inputs
Correction
Turn power switch on
Connect power cord to live outlet
Adjust both MASTER and CHANNEL
LEVEL controls upward to desired
level. Check speaker connections.
Turn mic switch on. Check mic or
sound source connection.
Make sure desired effect is selected
in Master effect menu. Check the
master EFX MUTE. If the LED is
illuminated the EFX MUTE is active.
Press the EFX MUTE button once to
disable. Adjust channel EFX control
until audio effect is heard.
Make sure once MEDIA SELECT knob
is rotated to display desired file
the knob is then pressed to cue the
file. Make sure your audio files are
the correct format. See the list of
supported audio formats mentioned
previously in this manual.
Reduce microphone gain. Reposition
microphone behind or farther
from speakers. Observe FLS light
above EQ and reduce level of
corresponding slider.
Reduce CHANNEL GAIN and increase
MASTER VOLUME
that limits the PA output to prevent
™