A SYSTEMS DMP808 Manual Del Usuario página 18

DMP808
RM-4 PRESET RECALL REMOTE
With a single RM-4 you will be able to recall up to 4
independent presets�
WIRING
The RM-4 can be wired to the "Preset" section on the
rear of the DMP8800�
As shown, there are pins for each of the 4 preset buttons
on the RM-4, as well as a grounding pin� Each of the 4
pins corresponds with a user-selected "Scene" within the
control software�
English
Suggested wiring:
SETUP AND OPERATION
To utilize the RM-4, you simply need to assign a preset
to each of the buttons� This is done within the Control
Software of the DMP 8800� First, enter the "Global
Settings" menu and find the GPIO submenu� Here you
will find the "Preset" panel (shown below). Each of the
pins on the rear of the device will correspond to the Ports
listed here. You can then select which "Scene" (or preset)
you wish to assign to that port�
The pre-saved scenes are all listed within the Utility
menu. Scenes can be saved (and recalled) in this
menu� The "No" in the Preset window on the GPIO
page will correspond with the 'Scene' numbers found
here� The Subject in the Preset window will be updated
automatically�
A single preset can be recalled at any one time� The
button selected on the RM-4 will lock down, releasing
any other preset button that may have previously been
selected�
16