Safety Instructions; Shipping And Storage; Assembly And Adjustments - Vermeiren Twin-Light Manual De Instrucciones

by improper use or lack of maintenance will
cause the warranty to lapse.

3.3 Safety instructions

CAUTION
Please read and follow the instructions in
this manual. Otherwise you may get
injured, or your walker may get damaged.
• Check that no stones or other objects
block the wheels of the walker.
• While walking, keep both hands on the
handgrips.
• Be aware that some parts of your walker
may get very hot or cold due to ambient
temperature, solar
devices, etc. Be careful when touching.
• Before
every use,
handgrips are firmly secured, see §4.2.
• Do not hold the handgrips with wet hands.
If you do so, you can lose your grip and
lose your balance.
• Do not proceed with your walker into
traffic. Always stay on the pavement.
• Take note of the instructions for care and
service. The manufacturer is not liable for
damage caused by improper servicing /
care.
3.4 Symbols on the walker
Identification plate is located on the left
rear leg at the inner side of the base frame
Maximum weight of user in kg
Type designation

3.5 Shipping and storage

The shipping and storage of the walker should
happen according
specifications in §7. Make sure that the walker
is stored dry.
Provide sufficient covering or packaging to
protect the walker from rust and foreign
bodies (e.g. salt water, sea air, sand, dust).
Make sure no objects are stored on or against
the walker to prevent damage.
Risk of injuries
radiation, heating
check that the
to the technical
4

Assembly and adjustments

4.1 Assembly
1. Place the walker on its legs and wheels.
Make sure that it stands stable.
2. Slide the handgrip (1) into the frame tube
(2).
3. Insert the screw and place the star knob
(3). Tighten the star knob to secure the
handgrip into place.
4. Repeat for the second handgrip. Make
sure that both handgrips are well secured,
and that they are set to the same height.
1
4.2 Height adjustments
The walker can be altered in height by
adjusting the handgrips (7 positions, in steps
of 25 mm).
1. Remove the star knob (3) and screw.
2. Slide the handgrip (1) up/down in the
frame tube (2) to the desired height.
3. Replace the screw in the corresponding
hole and firmly retighten the star knob (3).
4. Repeat for the other handgrip.
Make sure that both handgrips have been set
to the same height.
3
Twin-Light
2019-12
Assembly and adjustments
3
2
EN
NL