Installation Instructions; Step 1 - Unpack Refrigerator - Haier HC32TW10SB Manual Del Usuario

INSTALLATION INSTRUCTIONS

STEP 1 - UNPACK REFRIGERATOR

Do not puncture refrigerant tubing.
Follow handling instructions carefully.
Flammable refrigerant used.
Failure to do so can result in death, explosion or fire.
IMPORTANT: Handle with care when moving refrigerator to avoid either
damaging the refrigerant tubing or increasing the risk of a leak.
IMPORTANT: When moving the refrigerator, never tilt it more than a 45°
angle. This could damage the compressor and the sealed system. If the
refrigerator has been placed in a horizontal position for any period of time,
wait 30 minutes before plugging in the refrigerator to allow the refrigerant
to settle.
REMOVE PACKAGING
Remove tape and glue residue from surfaces before turning on the
refrigerator. Rub a small amount of liquid dish soap over the adhesive with
your fingers. Wipe with warm water and dry.
NOTE: Do not use sharp instruments, rubbing alcohol, flammable fluids,
or abrasive cleaners to remove tape or glue. These products can damage
the surface of your refrigerator. For more information, see "Refrigerator
Safety."
Dispose of/recycle all packaging materials.
CLEAN BEFORE USING
After you remove all of the packaging materials, clean the inside of the
refrigerator before using it. See the cleaning instructions in "Refrigerator Care."
CAUTION
when they are cold. Shelves and covers may break if exposed to sudden
temperature changes or impact, such as bumping. Tempered glass is
designed to shatter into many small, pebble-size pieces. This is normal.
Glass shelves and covers are heavy. Use both hands when removing
them to avoid dropping.
49-60808-1
WARNING
Explosion and Fire Hazard
Do not clean glass shelves or covers with warm water
9