Publicidad
Idiomas disponibles
Idiomas disponibles
GB
TP 220
Procedure
Place the device in position and roll along
the surface of the wallpaper while apply-
ing minimal pressure.
You will obtain better results if you move
the device in the direction of the arrow
and avoid tipping the perforating head.
(see illustration below)
Work breaks and finishing work
Always attach the protective cover to the
device after finishing work
7
Service and maintenance
7.1
Replacing the blade rollers
CAUTION
Sharp, pointed edges!
Risk of injury!
Handle the device with extra care and al-
ways wear suitable protective gloves.
[Fig. 5]
Loosen the flat head screws by turning
the auxiliary plates at either end of the
roller in opposite directions.
Remove the first roller.
Remove the second roller from the device
together with the shaft and then pull the
roller from the shaft.
Slide a new roller onto the shaft.
Note: The points on the roller
should always point towards the
centre of the device.
Insert the roller with shaft into the device
and attach the second roller (Note direc-
tion!).
Tighten the two screws.
Replace the second pair of rollers in the
same way.
10
8
Use only original Festool accessories and
Festool consumable material intended for
this machine because these components are
designed specifically for the machine. Using
accessories and consumable material from
other suppliers will most likely affect the
quality of your working results and limit any
warranty claims. Machine wear or your own
personal workload may increase depending
on the application. Protect yourself and your
machine, and preserve your warranty claims
by always using original Festool accessories
and Festool consumable material!
The order numbers of the accessories and
tools can be found in the Festool catalogue or
[Fig.
3].
on the Internet under "www.festool.com".
9
We offer a warranty for material and produc-
tion defects for all our tools in accordance
with the locally applicable legal provisions,
but for a minimum of 12 months. Within the
EU member states, the warranty period is 24
months (verification through invoice or deliv-
ery note). Damage caused by the operator,
natural wear, overloading, incorrect handling
or through the use of the equipment not
specified in the operating manual, or damage
which was known at the time of purchase, is
not covered by the warranty. Furthermore,
damage caused by the use of non-original
accessories and consumable materials (e.g.
sanding pads) is also excluded.
Complaints can only be accepted if the tool is
returned while still assembled to the supplier
or an authorised Festool Customer Service
workshop. Keep the operating manual, safe-
ty instructions, spare parts list and purchase
receipt in a safe place. Otherwise the current
warranty conditions of the manufacturer
shall apply.
Note
Due to continuous research and develop-
ment work, we reserve the right to make
changes to the technical content of this doc-
umentation.
The play of the blade rollers ensures that
the device will function correctly over
slightly uneven surfaces.
Accessories
Warranty
Publicidad
