Setting For Dvd Player; General Setup Page - Sony MV-700HR Manual De Instrucciones

Setting for DVD player

- General Setup Page

- - G e n e r a l
M o n i t o r T y p e
A n g l e M a r k
S c r e e n S a v e r
C o l o r S y s t e m
D e f a u l t
S e l e c t : < , S e t : E n t e r Q u i t : S E T U P
♦
Monitor Type
When you connect the player to a TV to watch
the DVD on TV screen, make this setting
according to the type of the TV screen.
The default settings are underlined.
4:3/Pan Scan
Select this when you connect a
4:3 screen TV. The wide
picture will be automatically
displayed on the entire screen
and the portions that do not fit
will be cut off.
4:3/Letter Box Select this when you connect a
4:3 screen TV. The wide
picture with the bands on the
upper and lower portions of
the screen will be displayed.
16:9 Select this when you connect a
wide-screen TV or a TV with a
wide mode function.
♦
Angle Mark
If various angles (multi-angles) for a scene are
recorded on the DVD and you have set the
"Angle Mark" to "On", a notice appears at the
scene.
On
A notice will appear at the scene.
Off A notice will not appear at the scene.
30
S e t u p P a g e - -
O n
O n
N T S C
♦
Screen Saver
If you set the "Screen Saver" setting to "On",
the screen saver image appears when you
leave the player in pause or stop mode for
more than 15 minutes. The screen saver will
prevent the monitor from damage.
On Turns on the screen saver.
Off Turns off the screen saver.
♦
Color System
When you connect the player to a TV to watch
the DVD on TV screen, make this setting
according to the color system of your country.
PAL
Always outputs the PAL signal.
NTSC
Always outputs the NTSC signal.
♦
Default
You can reset setup menus to the factory
setting.
1
Press (SETUP), then press < or ,
button repeatedly until "General Setup
Page" appears on the screen.
2
Press (ENTER).
3
Press M or m button repeatedly to select
"Default".
4
Press (ENTER).