Remote Control; Software Update - Sony HT-G700 Manual De Instrucciones

 Reposition the connected
BLUETOOTH device.
 Switch the wireless LAN frequency of
any nearby wireless LAN router or PC
to 5 GHz range.
 Increase the volume on the
connected BLUETOOTH device.

Remote Control

The remote control of the system
does not function.
 Point the remote control at the
remote control sensor on the bar
speaker (page 11).
 Remove any obstacles in the path
between the remote control and the
system.
 Replace both batteries in the remote
control with new ones, if they are
weak.
 Make sure you are pressing the
correct button on the remote control.
TV remote control does not work.
 This problem might be solved by
setting [SYSTEM] - [IR REPEATER] to
[ON] (page 37).

Software Update

You cannot perform the software
update.
 Use the USB memory on which the
software update file is stored to
perform the software update
(page 37).
Others
The Control for HDMI function does
not work properly.
 Check the connection with the
system (refer to the supplied Startup
Guide).
 Enable the Control for HDMI function
on the TV. For details, refer to the
operating instructions of your TV.
44
US
 Wait a while, and then try again. If
you unplug the system, it will take a
while before operations can be made.
Wait for 15 seconds or longer, and
then try again.
 Make sure the devices connected to
the system support the Control for
HDMI function.
 Enable the Control for HDMI function
on the devices connected to the
system. For details, refer to the
operating instructions of your device.
 The type and number of devices that
can be controlled by the Control for
HDMI function is restricted by the
HDMI CEC standard as follows:
– Recording devices (Blu-ray Disc
recorder, DVD recorder, etc.): up to
3 devices
– Playback devices (Blu-ray Disc
player, DVD player, etc.): up to 3
devices
– Tuner-related devices: up to 4
devices
– Audio system (receiver/
headphones): up to 1 device (used
by the system)
[PROTECT] flashes in the front panel
display and the system is turned
off.
 Disconnect the AC power cord (mains
lead) and make sure nothing is
obstructing the ventilation holes of
the system.
Sensors of the TV do not work
properly.
 The system may block some sensors
(such as the brightness sensor), the
remote control receiver of your TV or
the emitter for 3D glasses (infrared
transmission) of a 3D TV that supports
the infrared 3D glass system, or
wireless communication. Move the
system away from the TV within a
range that allows those parts to
operate properly. For the locations of
the sensors and remote control
receiver, refer to the operating
instructions supplied with the TV.