LD Systems LD dave8roadie Manual De Usuario página 7

connectionS, ControLs, anD inDiCators:
1
Power SocKet
IEC power socket 220V-240V with built-in fuse holder
IMPORTANT INFORMATION: Replace the fuse only with a fuse of the same type and rating. If the fuse blows
repeatedly, please contact an authorised service centre.
2
Power
On / off switch. Before switching the system on or off, always adjust the volume to zero (Main Level all the
way to the left).
3
SPeaKer out (leFt / riGht)
Speakon-compatible speaker output (minimum impedance 4 ohms). Connector for the DAVE8 ROADIE
satellite speakers.
4
main leVel
Overall volume adjustment. The subwoofer volume is also adjusted in accordance with the preset on the SUB
LEVEL level control.
5
SuB leVel
Sets the relative volume of subwoofer and satellite speakers.
6
Power leD
Lights up when the PA system is switched on and properly connected to the power mains.
7
Protect leD
Lights up after power-on as long as the power-on delay is active. After the Protect LED goes out, the PA
system is ready for operation.
The Protect LED lights up when one of the power amplifier protection circuits is active. Once the source of
the trouble has been eliminated (e.g., overloading or a short circuit at the speaker output), after a short time,
the PA system returns to normal status, the Protect LED goes out, and the system is ready for operation
again. If the Protect LED does not go out after a short time even if all inputs and outputs have been discon-
nected, there is an internal fault. In this case, turn off the PA system, disconnect it from the power mains,
and hand it over to an authorised service centre.
8
PhaSe
Phase reverse switch for the subwoofer (0°, 180°).
9
line inPut (leFt / riGht) BalanceD
Balanced line input (XLR / 6.3 mm jack combo) for connection of an external audio source (e.g., mixer, keyboard).
10
line inPut (leFt / riGht) unBalanceD
Unbalanced line input (RCA) for connecting an external audio source (e.g., laptop).
7