General Safety Precautions - Wagan Tech 2404 Manual De Usuario

3 Million Brite-Nite ™ Spotlight Lantern by Wagan Tech

GENERAL SAFETY PRECAUTIONS

• Do not turn on light while charging the unit. Doing so will damage the unit and will void
your warranty.
• As with all lead-acid cell batteries, when storing, be sure to recharge the battery fully
every 3-6 months to prolong the life of the battery.
• Turn OFF all lamp functions and allow unit to cool before storage.
• Though durable and built to last, do not drop the unit excessively as this will greatly
reduce the life of the unit.
• Though weather resistant, do not submerge the unit.
• Lens becomes very hot during operation.
• Do not cover lens or reflector during operation.
• Do not shine directly into eyes.
• Switch off and allow it to cool before storage or maintenance.
• When servicing always wear safety glasses when working with hardware.
• Use only supplied chargers.
• This unit is intended to be correctly orientated in a vertical or floor mount position.
OPERATING INSTRUCTIONS
This Spotlight Lantern is versatile and convenient to use. The large handle and rocker switch
placement allows for easy control of all lamp functions while carrying the unit. Two Rocker type
switches have three positions each and are marked I, O, and II. Always store the lamp with both
switches in the "O" position.
The two rocker switches and their functions are shown in the table below.
Switch Location/Function Rocker Switch 1 (closest to
spotlight end)
"O" Position Function OFF
"I" Position Function Spotlight ON
"II" Position Function Flashing Red Emergency
Beacon
www.wagan.com
3
®
Rocker switch 2
OFF
Single fluorescent tube ON
Two fluorescent tubes ON
User's Manual—Read before using this equipment
RECHARGING THE UNIT
Your spotlight is supplied with two charging adapters. One adapter is powered by standard
115 volts AC. This is the AC/DC Charging Adapter. The other charging adapter is the DC/DC
Charging Adapter. This adapter has a user-replaceable fuse in the DC plug that connects to a
cigarette lighter outlet (accessory outlet). Be sure to charge the unit completely before the first
use (charge for 24 hours). This step will prolong the life of the internal battery. Use the AC/DC
Charging Adapter for the first charge.
AC Charging
The AC/DC adapter provides a slow steady charge to the unit. Do not operate the lamp while
the AC/DC Charging Adapter is charging the lamp, you may damage the charging adapter and
discharge the lamp's batteries. Charge for a maximum of sixteen hours; DO NOT overcharge.
1. Make sure that all switches are set to "O", the off position.
2. Using the AC/DC adaptor, insert the DC end into the Charging Jack (next to the flare
light).
3. Plug the AC end into a wall outlet.
4. The red Charging LED light will come on to indicate the lamp is charging.
DC Charging
Any 12 Volt DC power outlets, such as in vehicles, boats, and jump starters can charge this lamp
using the DC/DC Charging Adapter. For full charge, the power source must be from a vehicle
or boat DC outlet and the engine should be running. Charge for five hours maximum; DO NOT
overcharge.
1. Make sure that all switches are set to "O", the off position.
2. Using the DC/DC charger, insert the DC end into the Charging Jack (next to the flare
light).
3. Plug the larger DC plug into the cigarette lighter outlet.
4. The red Charging LED light will come on to indicate the lamp is charging.
©2012 Wagan Corporation
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
All Rights Reserved.
4