Technical Specifications - Pro-Ject Audio Systems Speaker Box 10 E Manual De Instrucciones

(BLACK) terminal on your amplifier. Repeat the instructions for the left-hand channel. Do NOT connect more
than one loudspeaker to one terminal on your amplifier.
Please set the volume level to minimum before switching on the amplifier!
!
Phasing
Providing that you have followed the connecting instruction correctly the loudspeakers should
be in phase and provide solid stereo images. If however, you have any doubt as to the phasing of the
loudspeakers, try reversing the connections (RED & BLACK) to ONE of the loudspeakers, and play a
recording which has plenty of deep bass operating both loudspeakers simultaneously with the stereo
amplifier switched to „mono". The correct polarity is indicated by firm full bass, when incorrect, the bass will
be noticeably much weaker.
Service
No routine attention is required to the working parts of the loudspeakers and being very reliable
loudspeakers rarely require service. Any service problems should in the first instance be referred to your
dealer.

Technical specifications

Enclosure type
Recommended amplifier power:
Frequency response:
Nominal impedance:
Sensitivity:
Chassis:
Dimensions H x W x D:
Weight:
4
© Pro-Ject Audio Systems · Pro-Ject Speaker Box 10 E · Revision 1.1
Pro-Ject Speaker Box 10 E
bass reflex via rear firing port
10 to 150 watts
50Hz - 20kHz
4 ohms
90dB (1w /1m)
1" silk dome tweeter
4,5" paper cone bass/mid (2 pc.)
920 x 140 x 190 mm (excluding spike feet)
945 x 140 x 190 mm (including spike feet)
11,7kg each