Operation; Inspection And Maintenance - Surtek H6024 Manual De Usuario

Primer bulb
4. Your unit is designed with a 2 position
choke, "CHOKE", "OPEN". Move choke lever
to CHOKE " " position
5. Grip handle firmly.
6. Pull starter rope briskly 4 times. A smooth
rapid pull is required for a strong spark
7. After engine starts and after 10 seconds
warm-up move choke lever to OPEN "
sition
NOTE: Always pull starter rope straight out.
Pulling starter at an angle will cause rope to
rub against the eyelet. This friction will cause
the rope to fray and wear more quickly. Always
hold starter handle when rope retracts. Never
let a rope snap back from extended position.
This could cause rope to snag or fray and also
damage the starter assembly.
STARTING A WARM ENGINE
1. Make sure the choke it's on OPEN position
2. Follow step 2 & 6 of STARTING A COLD EN-
GINE section.
TO STOP ENGINE
To stop motor release throttle valve and press
the switch in the OFF position " 0 "

OPERATION

IMPORTANT!
When operating, if the hedge trimmer blades
suddenly stops please check:
· If the branches are too rough; choose to trim-
mer branches below 8 mm.
· If the cutting is worsen; check if the blade is
wear or the gap between the blade is too big.
USING THE HANDLE
While cutting branches, in order to make accu-
rated cuts, double-edge trimmer can be swivel
from 0˚ to 90˚ to the left or right.
Proceed as follows:
NOTE: The hedge trimmer can be running
when changing the handle angle (but not
functioning).
1. Hold firmly the front handle, without action-
ing the starter, pull bracket to liberate the han-
dle and rotate (to 45˚ or 90˚ to the left or right).
2. Release the bracket
when the handle is
well positioned.
3. You can start work-
ing after the bracket
and handle is locked
in a position.
Choke
or adjustment make sure that hedge trimmer
is stopped. Not following this recommendation
will lead to accidents and personal injuries.
" po- • The blades are very sharp, a wrong operation
will lead to accident or personal injuries, please
follow safety rules along with the recommen-
dations of this manual, thus please read this
manual carefully.
• Never let the blades get close to the body or
others.
• Clean stuck branches from the blades (mak-
ing sure the blades and the trimmer stop func-
tioning).
• When operating make sure to use proper and
security clothing such as gloves, googles and
ear protection.
OPERATION
1. While trimming, you should go along with
the trimming cut (forward). As a safety recom-
mendation it's not allowed to go backwards
since this may cause you tripping.
2. Ensure that you operate in normal environ-
ment, keep yourself away from rocks, thick
branches, hard wood, wires, plastics, etc.
3. Never use this machine for branches above
8 mm of thickness.

INSPECTION AND MAINTENANCE

CAUTION: Make sure to stop the engine and
leave it cool down before making any inspec-
tion or maintenance.
AIR CLEANER SERVICE
NOTE: Every 25 hours of use give maintenance
to the air cleaner.
A dirty air cleaner will restrict air flow to the
carburetor. To prevent carburetor malfunction,
service the air cleaner regularly. Service more
E N G L I S H
WARNING: Before making any inspection
U ser 's M anual
Bracket
5