Operation - Cameo MATRIX 300 RGB Manual De Usuario

14
CARRY HANDLE
Two carry handles are provided at the back of the device so as to facilitate transport and mounting.
15
SAFETY EYELET
An eyelet for a safety cable is to be found at the upper edge of the device at the back.
Overhead installation may only be carried out by qualified personnel. A suitable safety cable must be fitted to the eyelet to ensure that the
spotlight does not fall down.

OPERATION

A few seconds after being switched on, the spotlight is ready for operation and the previously selected operating mode is activated.
CONFIGURE DMX START ADDRESS
Press MODE repeatedly until "Addr" appears in the display. Now press ENTER and configure the DMX start address using UP and DOWN as
required (A001–A512). Confirm your entry by pressing ENTER. For synchronous control of several spotlights of the same model using a DMX
device (e.g. DMX console), configure the lights with identical DMX start addresses and the same DMX mode setting and connect them using
DMX cables. If there is no DMX signal, the display characters will flash. Flashing stops as soon as a DMX signal is present.
-> ENTER-> UP/DOWN
6
15
13
12
14
13
-> ENTER
<- MODE
14