Pairing; What Is Pairing; Procedures Of Pairing - Sony TMR-BT10 Manual De Instrucciones

Pairing

What is pairing?

BLUETOOTH devices need to be
"paired" with each other beforehand.
Once BLUETOOTH devices are
paired, there is no need for pairing
again, except in the following cases:
• When pairing information is
deleted after repair, etc.
• When this unit is paired with 9 or
more devices.
This unit can be paired with 8
BLUETOOTH devices; if a new
device is paired after 8 devices
have been paired, the device
whose latest connection time is
the oldest among the 8 paired
devices is replaced by the new
one.
• When recognition of the unit by
the device to be connected is
deleted.
• When this unit is initialized.
All pairing information is deleted.
Note
Passcode* of this unit is fixed at "0000."
This unit cannot be paired with a
BLUETOOTH receiving device whose
Passcode is not "0000."
* Passcode may be called "Passkey,"
"PIN code," "PIN number," or
"Password."

Procedures of pairing

1
Place a BLUETOOTH
receiving device within
1 m (3 ft) of this unit.
2
Press and hold the
POWER button for 7
seconds or more to
standby for pairing while
the unit is turned off.
The indicator (blue) and the
indicator (red) start flashing
together and this unit starts
searching the BLUETOOTH
receiving device.
Notes
• After about 3 seconds, power is
turned on and the indicator
(blue) and indicator (red) flash
together twice. Keep the button
pressed without releasing until
both indicators start flashing
together, then release the button.
This unit enters into pairing
mode.
• If pairing is not established
within about 5 minutes, pairing
mode will be canceled and this
unit will turn off. In this case,
start over from step 1.
Continued
9
US