Yamaha NS-SW700 Manual De Instrucciones página 7

7 POWER switch
Set this switch to the ON position to use the subwoofer.
In this state, you can turn on the subwoofer or turn the
subwoofer into the standby mode by pressing the
STANDBY/ON button. Set this switch to the OFF
position to completely cut off the subwoofer's power
supply from the AC outlet.
8 OUTPUT (TO SPEAKERS) terminals
Can be used for connecting to the main speakers.
Signals from the INPUT1 terminals are sent to these
terminals.
(Refer to "CONNECTIONS" for details.)
9 INPUT1 (FROM AMPLIFIER) terminals
Used to connect the subwoofer with the speaker
terminals of the amplifier.
(Refer to "CONNECTIONS" for details.
0 INPUT2 terminals
Used to input line level signals from the amplifier.
(Refer to "CONNECTIONS" for details.)
A INPUT3 (LFE) terminals
The HIGH CUT control 2 has no effect on the signals
inputted to these terminals. (See Page 7 for details)
B AUTO STANDBY (HIGH/LOW/OFF) switch
This switch is originally set to the OFF position. By
setting this switch to the HIGH or LOW position, the
subwoofer's automatic power-switching function
operates, as described on page 11. If you do not need
this function, leave this switch in the OFF position.
* Make sure to change the setting of this switch only
when the subwoofer is set in the standby mode by
pressing the STANDBY/ON button.
C PHASE switch
This switch is to be set to the REV (reverse) position.
However, depending on your speaker system or
listening condition, there may be a case when better
sound quality is obtained by setting this switch to the
NORM (normal) position. Select the best position by
ear.
CONTROLS AND THEIR FUNCTIONS
5
En