Oster 1694 Manual De Instrucciones página 4

INSTRUCTIONS FOR USE
BEFORE USING FOR THE FIRST TIME
Read and follow all the instructions for this section on use and care and find a place to keep
this instruction manual ready for future reference.
For your convenience, record the complete model number (located at the bottom of the motor)
and the date you received the product, together with your purchase receipt and attach to the
warranty and service information. Retain in the event that the warranty service is required.
NOTE: The use of attachments not recommended or sold by Sunbeam Products, Inc. may
cause fire, electrical shock, injury or damage to the product.
Carefully unpack contents from carton.
1. Insert Lower Pole through the hole in the center of base and twist clockwise into position.
Be sure to align the groves on the threaded joint with the raised slots protruding from the
base center walls.
2. Turn the Base upside down (pole facing the floor) and place the weight over the threaded
pole end. The threads will be exposed as they protrude through the weight.
3. Secure the Weight to the Base by tightening the Base Nut in a clockwise direction.
NOTE: DO NOT use a tool to tighten the Base Nut.
4. Insert the remaining Pole with the Threaded Joint into the hollow end of the pole
connected to the Base and Twist Clockwise to secure.
5. Insert the neck of motor housing into hallow end of Upper Pole and turn the neck
clockwise to lock into place.
6. Position the Rear Grill over the Motor Shaft, making certain the 2 notches at the top and
bottom of the Rear Grill fit over the 2 prongs on the motor housing. Secure the Rear Grill
in place with the Rear Grill Mounting Nut. Turn mounting nut clockwise and tighten firmly.
7. Position the Large Fan Blade, with hollowed interior of the blade facing towards the Rear
Grill, firmly onto the Motor Shaft. Align the Motor Shaft pin with the recessed groove in the
back of the fan blade. Be sure the shaft protrudes from the front of the blade.
8. Position the Small Fan Blade, with guide pins into the hollowed interior of the Large blade,
and press firmly into place. Also be sure the shaft protrudes from the front of the blade.
9. Secure the fan blade onto the Motor Shaft by turning the blade cap counter-clockwise and
tighten firmly.
10. Center the Front Grill by aligning the Oster
then place into the Rear Grill. Snap the front and rear grills completely together. Tighten
the Grill Screw at the bottom of the Rear Grill. (NOTE: If Logo Plate is not already
assembled to Front Grill, you must attach it by aligning the slots located on the back side
of the logo plate with the notches in the grill center. Press firmly into place.)
ASSEMBLY INSTRUCTIONS
logo horizontally and parallel to the floor, and
®
3