Other Functions; Adjusting The Sound Characteristics; Turning On The Clock Display; Power Select Function - Sony CDX-3500 Manual De Instrucciones

If you cannot tune in a preset
station
Push and release the SEEK/AMS control
up or down to search for the station
(automatic tuning).
Scanning stops when the unit receives a
station. Push the SEEK/AMS control up or
down repeatedly until the desired station is
received.
Note
If the automatic tuning stops too frequently, press
(SENS/BTM) repeatedly until "LCL" (local seek
mode) is displayed. Only the stations with
relatively strong signals will be tuned in.
Tip
If you know the frequency of the station you want
to listen to push the SEEK/AMS control up or down
and hold until the desired frequency appears
(manual tuning).
If FM stereo reception is poor
— Monaural Mode
Press (SENS/BTM) repeatedly until
"MONO" appears.
The sound improves, but becomes
monaural ("ST" disappears).
To return to normal mode, press again until
"MONO" disappears.
Changing the display item
Each time you press (DSPL), the item changes
as follows:
z Frequency
MOTION DISPLAY* Z
* All the above items are scrolled in the display
one by one in order.
z Clock

Other Functions

Adjusting the sound
characteristics
You can adjust the bass, treble, balance, and
fader. You can store the bass and treble levels.
1
Select the item you want to adjust by
pressing (SOUND) repeatedly.
BAS (bass) n TRE (treble) n
BAL (left-right) n FAD (front-rear) n
VOL (volume)
2
Adjust the selected item by rotating the
dial.
Adjust within three seconds after selecting
the item. (After three seconds, the dial
function reverts to volume control.)
Turning on the clock
display

— Power Select Function

Only for cars with an accessory position on the
ignition key switch
To turn the Power Select Function ON
Press (OFF) while pressing (SOUND).
The Power Select Function ties the clock
display power to the accessory position on
the ignition key switch.
To avoid battery wear, the clock is not
displayed while the unit is initializing.
7