Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
AHPCL10 POWER CONDITIONER STRIP WITH RACK LIGHT
FRONT PANEL
1
2
1.
Circuit breaker: when the total current draw of the switched rear outlets and the front panel unswitched
convenience outlet exceeds 10 amps the circuit breaker will trip. Disconnect one or more pieces of your rack
equipment to reduce current draw. To reset the circuit breaker let it cool for a minute, then push it in gently
until it latches.
2.
Dimmer control: this adjusts the pull-out LED lights' brightness.
3.
LED rack lights: the 5-LED lights switch on automatically when pulled out. To turn them off slide the barrels
back in. Use the Dimmer control (see 2) to set the brightness level.
4.
Vent: the front panel vent openings provide convection cooling of the AHPCL10.
5.
Unswitched convenience outlet: this IEC outlet is active whenever the AHPCL10's power cord is connected
to an appropriate mains outlet. It is not affected by the "Outlets" switch (see 6).
6.
Outlets switch: this activates and disables the rear panel outlets. The red status indicator inside the switch
is lit when the rear outlets are enabled.
REAR PANEL
7
8
7.
Power cord: connect this to an appropriate mains outlet to power the AHPCL10.
8.
USB connector: connect the included gooseneck LED lamp to this socket to illuminate the rear of the rack.
9.
Switched IEC outlets: connect the power cords of your rack equipment to these AC outlets which are activa-
ted by the front panel "Outlets" switch (see 6).
10. Ground Lug: thumb screw ground terminal.
3
4
9
3
5
6
10
9
Publicidad
Tabla de contenido
