Pairing; What Is Pairing; Pairing Procedures - Sony WALKMAN WLA-NWB1 Manual De Instrucciones

Pairing

What is pairing?

Bluetooth devices need to be "paired" with each other beforehand.
Once Bluetooth devices are paired, there is no need for pairing
again, except in the following cases:
 Pairing information is deleted after repair, etc.
 This unit is paired with 9 or more receiving devices.
This unit can be paired with up to 8 Bluetooth receiving device. If a
new device is paired after 8 devices have been paired, the device whose
latest connection time is the oldest among the 8 paired devices is
replaced by the new one.
 This unit is initialized.
All pairing information is deleted (page 18).

Pairing procedures

1
Connect this unit to the Walkman (page 7).
The power of this unit turns on.
2
Press and hold the power button of this unit for about 2 seconds to turn it
off.
3
Place this unit and the Bluetooth receiving device to be paired
together within 1 m.
4
Set the Bluetooth receiving device to enter "Pairing in process."
(See the operating instructions supplied with the Bluetooth receiving
device.)
Note
Passcode* of this unit is fixed at "0000. " Depending on the Bluetooth receiving
device, it may be necessary to input the passcode (in this case, "0000"). This
unit cannot be paired with a Bluetooth receiving device whose passcode is not
"0000. "
* Passcode may be called "Passkey, " "PIN code, " "PIN number, " or "Password. "

GB