Krups MG705 Instrucciones De Uso página 11

12
Cooking
14
16
18
20
4-7
minutes
13
15
17
19
18-19 When the cooking level is
reached, the indicator light will
stop flashing and you can hear
a « beep ». The next cooking
level indicator will flash when it
is reached. Open the appliance
and remove your food when
the desired level is reached.
12 The selected program light will stay on. The
appliance starts pre-heating and the preheat
indicator flashes during all the pre-heating
phase. You must wait until the preheat
indicator stops flashing before opening
the Grill and adding the food. Wait for 4-7
minutes.
13 When the pre-heating is complete, there
will be an audible beep and, the preheat
indicator will stop flashing and stays lit during
all the cooking process.
Comments: At the end of pre-heating, if the
appliance remains closed, the safety system
will turn off the appliance.
14-15 After pre-heating, the appliance is ready
for use. Open the grill and place the food on
the cooking plate.
Comments: if the appliance remains open
for too long, the safety system will turn off
the appliance automatically.
16-17 The appliance automatically adjusts
the cooking cycle (time and temperature)
according to the food thickness and quantity.
Close the appliance to start the cooking cycle.
The indicator "Rare" will flash to indicate that
the rare cooking level is in progress. A beep is
heard and the indicator light will permanently
stay lit once the level of cooking is reached
(for the best results do not open or move
your food during the cooking process).
Please note, especially on meat, it is normal
that cooking results vary depending on type,
quality and origin of food.
Note: for thinly-cut food, after closing
the device, the button « OK » might
flash and remain on « pre heating
fixed ». Press « OK » to enable the
appliance to recognize the food to
be cooked and launch the cooking
program.
20 When starting a new cooking cycle, close
the appliance without food on the plate. The
control panel will light up and set itself to
'choice of program' mode.
Restart to instruction #9 for a new cooking
cycle in automatic mode.
Comment: the security system will turn
off automatically if no program selection is
made.
11