Product Presentation - BTV GUARDIAN Manual De Instrucciones

Product presentation

The GUARDIAN high-security invisible lock has a main body (batteries not included),
EN
a base plate for its anchorage, four remote controls, base to accommodate bolts,
anchor bolts and instruction manual.
In order to prevent the receiving antenna from being damaged during transportation,
it is removed. Please install the antenna before using the product.
1
2
3
4
5
6
7
Installation
1. Close the door, place the mounting plate (5) and the bolt housing (4) between
the door frame and the door. Paint the holes to drill and fix the base with the
screws provided.
2. Fix the bolt body to the anchor base and tighten the 4 screws firmly so that it
is securely fastened.
Make sure that the bolts of the lock match correctly in the bolt housing part.
3. After installation, check with the remote control that it works properly.
Operating instructions
MAIN DRIVE BUTTONS:
Close the door: Press
Open the door: Press
REINFORCEMENT DRIVE BUTTONS:
The reinforcement circuit is normally in the off position. It can be activated in the
event of the main batteries being depleted. To activate it you will need to tap the
door several times in the place where the lock is installed. A beep will sound, then
tighten the reinforcement drive buttons (
a few seconds, you will return to the main drive.
6
on the remote control. A beep will sound.
on the remote control. Three beeps will sound.
1. Manual spinning knob
2. Battery cover
3. Battery cover screw
4. Bolt housing
5. Mounting plate
6. Receiving antenna
7. Remote control
& ); If you do not press them after