FENSA NMDO25S5GCRG Manual De Instrucciones página 22

Interrupting the cooking
You can stop the cooking whenever
believes appropriate to check the
food in two different ways.
1. Open the oven door. This will stop
the cooking allowing check on
cooking. Close the door and press
the button "Start / + 30s". Cooking
will continue from the point where it
was interrupted until the end of the
scheduled time.
2. If you see that the food is cooked
before the end of the programmed
time, press the Cancel / Pause button
2 times to cancel the program. By
watching the food being cooked or
heated, observe the safety
recommendations already described
in this manual.
Opening the oven door
The oven light is lit whenever the
oven is operating or door is open.
Keep warm
This oven has pre-programmed
setting for meals to reheat. In this
case, it is not necessary to program
the cooking time or power level, it is
only necessary to define portion.
1. Press Keep warm button.
2. Select the Portion key.
3. Press the Start / + 30s button. The
oven will start cooking and after
completion, the beep will sound three
times.
OPERATION
(start / + 30 s)
(cancel / pause)
(keep warm)
41
OPERATION
Changing the brightness of the
display
You can change the brightness of the
display, which can be adjusted in
three levels:
• High Intensity (default)
• Medium Intensity
• Low Intensity
Proceed as follows:
1. Press the number 2 button for 4
seconds. The beep will sound.
2. To decrease the light intensity (if
not in low intensity) press the number
1 button once or twice
until the desired intensity.
3. To increase the light intensity (if not
in high intensity) press the number 3
button once or twice until the desired
intensity.
4. Wait 2 seconds without pressing
any button, an alarm will beep and
the display will take the brightness
that has been selected.
Beep signal
Always when a correct command is
activated, the oven emits a beep. If
you press a button and do not hear a
beep, the oven did not accept the
command (review the selected
program).
At the end of each program the oven
emits a beep, it will automatically
turn off and return to indicate the
time, or 12:00 if not already
programmed the clock.
42