Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
The appliance should be set up in a well-ventilated, dry room. It should be operated in an ambient
temperature of 16 to 38 °C and a relative humidity of max. 70 %. Do not expose the appliance to
direct sunlight, and do not position it next to any heat sources (radiators, cookers etc).
–
The rear and the sides should have a minimum clearance of 10 cm from the wall.
–
The top clearance must be at least 15 cm.
The unit must not be installed inside a cabinet, nor directly below a hanging cupboard, shelf or
similar object.
Ensure that the door can swing open to an angle of 160°.
If the floor is uneven, the adjustable feet on the unit can be used to compensate and ensure optimum
stability. The whole unit should be installed at a slight angle in such a way that it leans to the rear:
this will ensure that the door closes automatically. However, both front feet must be set to the same
height.
Ventilation
The heated air around the rear of the unit must be able to circulate freely. Therefore, ensure that the
air circulation behind the unit is not obstructed.
Reversible door
The design provides for the door to be reversed, i.e. for right-hinged (default installation) to become
left-hinged.
Before reversing the door, place the unit on its side, ensuring that it rests on a soft, smooth, non-
damaging surface.
Caution: Before reversing the door, switch off the unit and disconnect it from the mains.
1. Remove the upper hinge cover (1).
2. Use a screw-driver to remove the two screws (2) holding the upper hinge (3) to the right side of
the housing.
3. Carefully lift up the door and place it on a soft surface to protect it from scratches.
4. Use a suitable pointed tool to remove the covers for the screw holes (12).
5. Pull out the two bolts (6) which hold the lower right hinge plate (10) in position.
6. Remove the bolt and the adjustable foot (5) on the left and fit them it into the corresponding
thread on the right.
7. Remove the hinge pin (11) and the adjustable foot (7) from the hinge plate (10) and replace them
on the other side of the hinge plate (10).
8. Install the lower hinge plate (10) on the left
9. Replace the door (turned through 180°) in its new position. Ensure that the hinge pin (11) is
inserted into the guide bushing (hole) on the lower part of the door.
10. Install the upper hinge (3) on the left-hand side, using the screws (2). Ensure that the hinge pin is
inserted into the guide bushing (hole) on the upper part of the door.
11. Replace the screw hole covers (12) in the corresponding holes on the right.
12. Replace the hinge cover (1) on the upper hinge.
12
Publicidad
