Technical Data - Cameo MOVOBEAM ZOOM 100 Manual De Usuario

of the next DMX device. In the same way, connect the DMX output of this device to the DMX input of the next device and repeat until
all devices have been connected. Please note that as a rule, DMX devices are connected in series and connections cannot be shared
without active splitters. The maximum number of DMX devices in a DMX chain should not exceed 32 units.
The Adam Hall 3 STAR, 4 STAR, and 5 STAR product ranges include an extensive selection of suitable cables.
DMX CABLES
When fabricating your own cables, always observe the illustrations on this page. Never connect the shielding of the cable to the ground
contact of the plug, and always make certain that the shielding does not come into contact with the housing of the XLR plug. If the shielding
is connected to the ground, this can lead to short-circuiting and system malfunctions.
Pin Assignment
DMX cable with 3-pin XLR connectors:
Shield
1
3
2
DMX TERMINATORS (TERMINATING RESISTORS)
To prevent system errors, the last device in a DMX chain needs to be equipped with a terminating resistor (120 ohm, 1/4 Watt).
3-pin XLR connector with a terminating resistor: K3DMXT3
5-pin XLR connector with a terminating resistor: K3DMXT5
Pin Assignment
3-pin XLR connector:
1
3
2
DMX ADAPTER
The combination of DMX devices with 3-pin connectors and DMX devices with 5-pin connectors in a DMX chain is possible with suitable
adapters.
Pin Assignment
DMX Adapter 5-pin XLR male to 3-pin XLR female: K3DGF0020
Pins 4 and 5 are not used.
Pin Assignment
DMX Adapter 3-pin XLR male to 5-pin XLR female: K3DHM0020
Pins 4 and 5 are not used.

TECHNICAL DATA

Model name:
Product Type:
Type:
Colour spectrum:
No. of LEDs:
LED type:
Refresh rate:
Beam angle:
LED colour ring:
DMX input:
DMX output:
DMX mode:
DMX functions:
Standalone functions:
1
3
2
CLMBZ100
LED moving light
Moving head
RGBW
1
60 W Osram
1000 Hz
4° - 30°
4 segments RGB
3-pin male XLR
3-pin female XLR
5-channel, 16-channel, 36-channel
Pan/tilt, pan/tilt fine, endless pan/tilt, pan/tilt speed, auto programmes, stroboscope, RGBW,
dimmer, dimmer fine, colour macros, zoom, colour ring colour macros, colour ring colour macro
speed, stroboscope colour ring, dimmer curves
auto programmes, static mode, master/slave
DMX cable with 5-pin XLR connectors (pin 4 and 5 are not used):
5
4
3 3
2
1
Shield
5-pin XLR connector:
5
4
3
2
1
5
4
2
1
11