Installation And Mounting; Dmx Technology; Dmx Connection - Cameo MOVOBEAM ZOOM 100 Manual De Usuario

System Info
Software Ver = Displays device software version
Temp info = Displays temperature of LED unit
Time info = Operating time display
Press MODE several times to return to the main display. The main display is activated automatically after approximately 30 seconds of no input.

INSTALLATION AND MOUNTING

Thanks to its integrated rubber feet, the spotlight can be positioned in a suitable location on the stage floor etc.
The device can be installed on a traverse using the Omega bracket supplied (only use the original mounting bracket); attach the device securely
at the specified position (A) using a suitable safety cable. Important: Overhead installation may only be carried out by qualified personnel.

DMX TECHNOLOGY

DMX-512
DMX (Digital Multiplex) is the designation for a universal transmission protocol for
communications between corresponding devices and controllers. A DMX controller sends
DMX data to the connected DMX device(s). The DMX data is always transmitted as a serial
data stream that is forwarded from one connected device to the next via the "DMX IN" and
"DMX OUT" connectors (XLR plug-type connectors) that are found on every DMX-capable
device, provided the maximum number of devices does not exceed 32 units. The last device
in the chain needs to be equipped with a terminator (terminating resistor).

DMX CONNECTION

DMX is the common "language" via which a very wide range of types and models of equipment from various manufacturers can
be connected with one another and controlled via a central controller, provided that all of the devices and the controller are DMX
compatible. For optimum data transmission, it is necessary to keep the connecting cables between the individual devices as short as
possible. The order in which the devices are integrated in the DMX network has no influence on the addresses. Thus the device with
the DMX address 1 can be located at any position in the (serial) DMX chain: at the beginning, at the end or somewhere in the middle.
If the DMX address 1 is assigned to a device, the controller "knows" that it should send all data allocated to address 1 to this device
regardless of its position in the DMX network.
SERIAL CONNECTION OF MULTIPLE LIGHTS
1. Connect the male XLR connector (3-pin or 5-pin) of the DMX cable to the DMX output (female XLR socket) of the first DMX device
(e.g. DMX-Controller).
2. Connect the female 3-pin XLR connector of the DMX cable connected to the first projector to the DMX input (male 3-pin socket)
10
VR. xx
LED Temp xxC / xxF
Celsius (= temperature in Celsius)
Temp Unit
Fahrenheit (= temperature in Fahrenheit)
Power on Displays total operating time in hours
Displays operating time since the last time the
Last Run Hrs
device was switched on
A