Basic Connections - Kenwood CMOS-130 Manual De Instrucciones

Connections

Basic Connections

Navigation system/video monitor (commercially available)
Camera
Camera's cord length: 75cm
CAUTION
• If the engine key of your vehicle does not have the ACC position, connect the red wire to a power source that is active when
the key is ON position.
• Before proceeding to connections, make sure that the engine key is not inserted and disconnect the (-) terminal of the
battery to prevent a possible short circuit.
6
|
ENGLISH
Connect to the rearview camera video input or to the external
video input of the video monitor.
Video out
Fuse (2A)
Accessory cord (Red)
Connect to the ON-OFF switchable power
supply. Do not connect to a permanently ON
power supply.
Connect to a metallic part of vehicle (a part of chassis
connected to the negative side of power supply).
Video cord (commercially available)
Fuse
Accessory power (ACC)
GND cord (Black)
Engine key
Main fuse
Battery
GND