OPERATION
Controls
The hood is operated using the (5) push-but-
tons located at eye-level, on the front edge of
the hood. Fig. 1.
The light button turns the halogen lights on
and off.
The blower on-off / speed 1 switch turns the
blower on to its lowest running speed. Press-
ing this switch a second time sets a TIMER
which keeps the blower operating at this
speed for 5 minutes. The corresponding LED
comes on during this time and the blower will shut off automatically. To turn OFF
the blower, push in and hold this blower switch for approximately 1 second.
The blower speed 2 switch turns the blower on to medium-low running speed.
Pressing this switch a second time sets a TIMER which keeps the blower operat-
ing at this speed for 5 minutes. The corresponding LED comes on during this time
and the blower will shut off automatically.
The blower speed 3 and blower speed 4 switches operate the same as blower
speed 2 switch except: Blower speed 3 is medium-high and blower speed 4 is
high.
After every 30 hours of operation, the LED of the "light button" comes on for 30
seconds after turning off the blower. This is a reminder to clean the grease filter.
Once the grease filter is cleaned and installed, press in and hold the "light button"
for approximately 1 second while the LED is on.
HEAT SENTRY™
Your hood is equipped with a HEAT SENTRY™ thermostat. This thermostat is a
device that will turn on or speed up the blower if it senses excessive heat above
the cooking surface.
1) If blower is OFF - it turns blower ON to HIGH speed.
2) If blower is ON at a lower speed setting - it turns blower up to HIGH speed.
When the temperature level drops to normal, the blower will return to its original
setting.
WARNING
The HEAT SENTRY thermostat can start the blower even if the hood is turned
OFF. When this occurs, it is impossible to turn the blower OFF with its switch.
If you must stop the blower, do it from the main electrical panel.
BLOWER
SPEED 4
BLOWER
SPEED 3
BLOWER
SPEED 2
BLOWER
ON-OFF /
SPEED 1
LIGHT
BUTTON
- 4 -
FIG. 1