Attaching Or Removing Bat­ Tery Pack - Panasonic EYFPA1J Manual De Instrucciones

Ocultar thumbs Ver también para EYFPA1J:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE:
EN
EN
Keep the temperature of the tool above
the freezing point (0°C/3°F) when
attaching sockets to or removing them
from the square drive on the tool. Do
not use excessive force when attaching
or removing sockets.
CAUTION:
When attaching a socket to the driver,
verify that the socket and pin-detent do
not interfere with one another.
[Fig.6]
Some sockets may not function well with
the driver due to their shape. Avoid use of
sockets such as the following:
1 Sockets shaped so that the pin-detent
makes contact with the side of the
socket's pin hole when the socket is
attached to the driver.
The pin-detent will be subjected to
excessive force, possibly damaging it.
[Fig.7]
2 Sockets with a pin hole on one side
only
You may be unable to remove the sock-
et if it is attached in the wrong orienta-
tion.
[Fig.8]
3 Sockets whose pin holes have beveled
edges
The socket will not be held in place with
sufficient force, so that it may come off
during use.
[Fig.9]
Attaching or Removing Bat­
tery Pack
1. To connect the battery pack:
Line up the alignment marks and attach
the battery pack.
Slide the battery pack until it locks into
position.
[Fig.10]
. To remove the battery pack:
Push down the button and slide the battery
pack forward.
[Fig.11]
Attaching the tool hanger
1. Remove the pin and the clip from the tool
hanger.
[Fig.12]
. Align the holes on the tool hanger with the
holes on the tool body.
[Fig.13]
3. Insert the pin into the holes on the tool
hanger and the tool body.
Attach the clip on the tool hanger's holes.
[Fig.14]
V.
OPERATION
WARNING
Do not inhale any smoke emitted from the
tool or battery pack as it may be harmful.
Comparison chart for EYFA31 / EYFA30
remote control
EYFA31
D button (P)
C button (Q)
B button (R)
A button (S)
This operating instruction is written with
the contents of EYFA31 model.
In the case of use with EYFA30, refer to
the above chart and replace EYFA30 with
EYFA31.
Before Using the Remote
Control (Available as an
optional accessory)
[Fig.15]
- 10 -
EYFA30
Torque level button (V)
Format button (W)
Interval set button (X)
Torque set button (Y)

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Eyfpa1jrEyfna1cEyfna1crEyfna1jEyfna1jrEyfna1p ... Mostrar todo

Tabla de contenido