Attaching Or Removing Bat- Tery Pack - Panasonic EYFLA4A Manual De Instrucciones

Attaching Socket (Pin type)
• Remove the socket's rubber ring and pin.
rubber ring
1 Attach the socket to the tool.
2 Insert the pin. (Taking care to align the pin
holes on the socket and tool.)
3 Attach the rubber ring by sliding it into place
over the groove.
NOTE:
Be sure to attach the rubber ring to prevent
the pin from falling out.
Removing Socket (Pin type)
1 Remove the rubber ring.
2 Remove the pin.
3 Remove the socket from the tool.
Attaching or Removing
Socket (Ball detent type)
1. Attaching Socket
Attach the socket by sliding the female
detent on the bottom of the socket to the
square drive on the body.
Make sure the
socket is firmly
connected to
the body.
. Removing Socket
Pull out the socket.
groove
pin
Attaching or Removing Bat-
tery Pack
1. To connect the battery pack:
Line up the alignment marks and attach
the battery pack.
• Slide the battery pack until it locks into
position.
Alignment
marks
. To remove the battery pack:
Push up on the button from the front to re-
lease the battery pack.
Button
IV
OPERATION
.
Before Using the Remote
Control (Available as an
optional accessory)
Insert the battery
1. Pull out the battery holder.
1 Push in on the fas-
tener as indicated by
the arrow.
2 Pull out the holder.
. Insert the bat-
tery and push the
holder back in.
- 7 -