Step 3: Connect The Display And Media Engine; Step 4: Connect The Audio Cord; Step 5: Connect The Power Cord; Step 6: Turn On The Monitor And Computer - Sony SDM-N80 Manual De Instrucciones

Step 3: Connect the display and
media engine
Turn off the display and media engine before connecting them.
To connect the system connecting cable to the display easily, set
the display in an upright position.
System connecting
cable (2 m) (supplied)
A
to SYSTEM
CONNECTOR
of the media
engine
Align the v on the plugs with the v on the display
and the media engine.
Caution
Be sure to install the media engine vertically as shown above. Installing
the media engine lying flat may block ventilation, and may cause a
malfunction.
Note
When connecting the cable, grasp the plug and insert it firmly into the
connector until you hear it click. When disconnecting the cable, pull out
the plug while holding down locking lever A .

Step 4: Connect the audio cord

to AUDIO IN jack
among the INPUT2
connectors
to an audio output jack
on your computer
Audio cord (supplied)
8
A
to SYSTEM
CONNECTOR
of the display

Step 5: Connect the power cord

With the media engine, display, and computer switched off,
first connect the power cord to the media engine, then connect it
to a power outlet.
to AC IN connector
to a power outlet
Power cord (supplied)
Step 6: Turn on the monitor and
computer
1 Turn on the media engine.
The display automatically turns on. The indicators of the
media engine and display light up in green.
2 Turn on the computer.
Note
If you turn off the media engine and turn it on again while the display is
off, the display will not turn on automatically. In this case, press the 1
(power) switch on the display to turn it on.