Hilti DD 200 Manual De Instrucciones página 23

Warning signs
General Warning:
warning electricity
en
Obligation signs
Wear eye Wear a safety
protection helmet
Symbols
Read the operating
instructions before
use.
A V
Amps Volts
~
rpm
Revolutions Alternating
per minute current
On the vacuum baseplate
VACUUM
VACUUM
Top:
An additional means of
securing the drill stand must
be employed when used for
horizontal drilling with
vacuum attachment.
Below:
Use of only the vacuum base-
plate to secure the drill stand
for overhead drilling is not
permissible.
18
Printed: 22.11.2013 | Doc-Nr: PUB / 5069597 / 000 / 03
Warning: hot
surface
Wear ear Wear safety Wear safety
protection gloves
Recycle
waste
material
W Hz
Watts Hertz Revolutions
∅
n
o
Nominal Diameter
speed under
no load
On the tool
Use of the water collector
system in conjunction with a
wet-type vacuum cleaner is
mandatory when working
overhead on ceilings.
boots
Use of a correctly functioning PRCD
circuit breaker is mandatory.
/min
These numbers refer to the corresponding illustra-
per minute tions. The illustrations can be found on the fold-out cov-
er pages. Keep these pages open while studying the
operating instructions.
In these operating instructions, the designation "the
machine" refers to the DD 200 core drilling machine.
Location of identification data on the machine
The type designation and serial number can be found
on the rating plate on the machine. Make a note of this
data in your operating instructions and always refer to
it when making an enquiry to your Hilti representative
or service department.
Type:
Serial no.:
Type:
Serial no.:
208188 B/2.2004
DD 200
DD-HD 30